為何排氣仍然還是一個問題？.pptxVIP

為何排氣仍然還是一個問題？ Why venting is still a problem ? 因為降低射速，讓積風有較多的時間逃氣，是一件太容易的事。但是… Because it is too easy to slow down the injection speed and give the trapped air more time to escape. But ...;射速一降，熔膠溫度很快降低，射壓必須提高，殘餘應力隨之提高，翹曲的可能性增加。 如果想藉提高料溫，以降低射壓，料溫必須升得很高，這樣又會引起塑料裂解。 When injection speed is lower, melt temperature goes down very fast, injection pressure has to be increased, residual stress is increased and the possibility getting warppage becomes higher. If one would like to increase barrel temperature to reduce the required injection pressure, the barrel temperature has to be increased to a qu