电子信息与工程专业毕业论文中英文资料外文翻译文献 AT89C51单片机.doc

毕业设计(论文) 中英文对照资料外文翻译文献 (此文档为word格式，下载后您可任意编辑修改！) 要 求 1、外文翻译是毕业设计（论文）的主要内容之一，必须学生独立完成。 2、外文翻译译文内容应与学生的专业或毕业设计（论文）内容相关，不得少于XXXX印刷符号。 3.外文翻译译文用A4纸打印,需包含中文翻译和英文原文。 4、年月日等的填写，用阿拉伯数字书写，要符合《关于出版物上数字用法的试行规定》2017年5月26日”。 5、所有签名必须手写，不得打印。 附件：外文原文 AT89C51 Description The AT89C51 is a low-power, high-performance CMOS 8-bit microcomputer with 4K bytes of Flash Programmable and Erasable Read Only Memory (PEROM). The device is manufactured using Atmel’s high density nonvolatile memory technology and is compatible with the industry standard MCS-51? instruction set and pinout. The on-chip Flash allows the program memory to be reprogrammed in-system or by a conventional nonvolatile memory programmer. By combining a versatile 8-bit CPU with Flash on a monolithic chip, the Atmel AT89C51 is a powerful microcomputer which provides a highly flexible and cost effective solution to many embedded control applications. Features Compatible with MCS-51? Products 4K Bytes of In-System Reprogrammable Flash Memory Endurance: 1,000 Write/Erase Cycles Fully Static Operation: 0 Hz to 24 MHz Three-Level Program Memory Lock 128 x 8-Bit Internal RAM 32 Programmable I/O Lines Two 16-Bit Timer/Counters Six Interrupt Sources Programmable Serial Channel Low Power Idle and Power Down Modes Pin Description VCC Supply voltage. GND Ground. Port 0 Port 0 is an 8-bit open drain bidirectional I/O port. As an output port each pin can sink eight TTL inputs. When 1s are written to port 0 pins, the pins can be used as highimpedance inputs. Port 0 may also be configured to be the multiplexed loworder address/data bus during accesses to external program and data memory. In this mode P0 has internal pullups. Port 0 also receives the code bytes during Flash programming, and outputs the code bytes during program verification.External pullups are required during program verification. Port 1 Port 1 is an 8-bit bidirectional I/O port with internal pullups. The Port 1 output buffers can sink/source four TTL inputs