电力系统交流电参量检测系统的研究-南昌航空大学期刊网.PDFVIP

实验研究〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉〉 理论研究 蔚晓明 陈琼 廖建庆 电力系统交流电参量检测系统的研究 83 1 2 2 ◎蔚晓明 陈琼 廖建庆 电力系统交流电参量检测系统的研究 （1.山西电力科学研究院，山西 太原 030001 ；2.南昌航空大学，江西 南昌 330063） [关键词]单片机；同步采样；串口通信；电参量算法 [摘 要]文章提出了电力系统中交流电参量检测系统软硬件设计。硬件设计采用了同步采样法，同步信号由4046 构成的锁相 倍频电路实现；信号的采集主要由互感器和运放构成的转换电路完成；AD 转换采用的是 12 位的AD574A 芯片完成；采集的电 压、电流数据经单片机处理后由RS232 构成的串口上传至上位机。软件部分是以下位机采集的数据为检测对象，用数字信号处 理技术对采样的数据进行分析，用DELPHI 进行编程，实现电参量分析及显示功能。 [中图分类号] TM93 [文献标识码] A [文章编号] 1001- 4926(2008)04- 0083- 05 Research of AC Parameter Detection System in Power System 1 2 2 WEI Xiao- ming ，CHENG qiong ，LIAO Jian- qing (1.Shanxi Electric Power Research Institute,Taiyuan 030001,China; 2.Nanchang Hangkong University,Nanchang 330063,China) ； ； ； Keywords: microcontroller synchronized sampling serial communication electricity parameter algorithm ： Abstract This paper has presended the hardware and software design of AC parameter detection system in power system.The synchronizing sampling has been used in the hardware design while the synchronized signal is generated by the phase-lock doubling circuit of 4046; Signal gathering is realized by the transform circuit of mutual inductor and operational amplifier. The AD convention is completed by the chip 12-bit AD574A; The sampled voltage and current data pass on to the supreme position machine through the serial interface RS232. The part of software has realized the function of the electricity parameter analysis and the demonstration, which is taking the sampling data from the lower position machine as the examination object, and carring on the analysis wit