VAR熔炼TC2钛合金.pdfVIP

Metallurgical Engineering 冶金工程, 2015, 2(3), 158‐167  Published Online September 2015 in Hans. /journal/meng  /10.12677/meng.2015.23023    The TC2 Titanium Alloy Melting for VAR 1,2* 2 2 2 2 Yabo Zheng , Zhanqian Chen , Feng Chen , Lu Qiao , Lingling Mao 1 Xi’an University of Architecture and Technology, Xi’an Shaanxi  2 Baoji Titanium Industry Co., Ltd., Baoji Shaanxi  * Email:  yabozheng@163.com    st st th Received: Sep. 1 , 2015; accepted: Sep. 21 , 2015; published: Sep. 29 , 2015  Copyright © 2015 by authors and Hans Publishers Inc.  This work is licensed under the Creative Commons Attribution International License (CC BY).  /licenses/by/4.0/    Abstract Since the saturated vapor pressure of aluminum and manganese in the titanium alloys are much greater than matrix elements, the volatilization loss of main group elements was greater in melt‐ ing, especially manganese, which is not conducive to the uniformity control of chemical composi‐ tion of the ingot. Based on the activity coefficient model and the controlled mass transfer coeffi‐ cient calculation model, this article analyzes the volatile trend of aluminum and manganese in the titanium melt, and the distribution characteristics of the elements in the TC2 titanium alloys. Combing with the actual production, by the reasonable control of raw materials, and selecting the appropriate alloying additives and melting parameters, TC2 titanium alloy with diameter of 720 mm was melted by VAR with inert gas protectio