管线钢边部翘皮缺陷形成机理探析.pdfVIP

管线钢边部翘皮缺陷形成机理探析 ·1 · 管线钢边部翘皮缺陷形成机理探析 焦晋沙 李振山 杨文静 夏碧峰 费书梅 崔全法 （首钢股份公司迁安钢铁公司，河北迁安 064400 ） 摘 要 本文针对管线钢热轧板出现批量边部翘皮缺陷事件进行了分析研究，利用扫描电子显微镜对边部翘皮缺陷 进行了微观分析，发现在翘皮区域出现了铁、锰氧化物和含Fe、Mn、Si、Ti 的高温氧化质点，同时对出现缺陷的 回炉坯及同浇次库存剩余板坯质量进行了复核，对此次边部翘皮缺陷形成原因进行机理探析。得出板坯切角后的残 余铁瘤、豁口缺陷是导致此次边部翘皮缺陷的主要因素，同时热轧过程除鳞不彻底等也是造成边部翘皮缺陷的可能 因素，通过加强板坯质量管理，确保板坯无缺陷轧制能够有效降低边部翘皮发生率。 关键词 边部翘皮，扫描电镜，连铸板坯，切角 Formation Mechanism Analysis of the Edge Shell Defect on the Pipeline Steel Jiao Jinsha, Li Zhenshan, Yang Wenjing, Xia Bifeng, Fei Shumei, Cui Quanfa (Shougang Qian’an Iron ＆ Steel Company, Qian’an 064400, China) Abstract The edge shell defect appeared on the surface of pipeline steel hot rolled plate were analyzed and studied in this paper. The Fe, Mn oxides and Fe, Mn, Si, Ti high temperature oxidation mass in edge shell area were found through microscopic analysis by scanning electron microscope. Reheating and rolling process of slabs and the same cast slabs were also checked to analysis the formation mechanism of edge shell. The analysis showed that the main reason of edge shell was the residual iron tumor and gap defects after cutting slab corner, and other possible reason was the incompletely scale removal process of the hot rolling and so on. Strengthening the slab quality management, in order to ensure slabs without defects could reduce incidence of the edge shell effectively. Key words edge shell, scanning electron microscopy, continuous casting slab, cutting angle 1 引言 随着石油和天然气工业的发展，管道运输已经成为最经济、方便，也是最主要的运输方式之一，从而大 大带动了管线钢的发展。管线钢很快成为各大钢铁厂的重点品种，及其拳头产品，管线钢的生产也受到极大 的重视，其产品质量也直接影响到各钢铁厂的经济效益。 近几年管线钢生产技术进步很大，其热轧板产品质量明显提高，但仍有文献[1~5]报道管线钢表面缺陷， 尤其边