SIMA法工艺参数对7075铝合金半固态组织的影响.PDFVIP

Hot Working Technology 2015,Vol.44,No.11 SIMA 法工艺参数对7075 铝合金 半固态组织的影响 李春晓 ，赵 丹，郑小平，田亚强，宋进英，陈连生 （河北联合大学冶金与能源学院，河北唐山063009 ） 摘 要：利用应变诱发熔化激活法（SIMA）制备了7075 铝合金半固态坯料。 分别研究了变形程度、半固态加热温度 与保温时间对7075 铝合金半固态坯料显微组织的影响。结果表明：变形程度越大，再结晶形核率越高，获得的半固态固 相颗粒越均匀、细小；半固态加热温度越高，则半固态组织的固相颗粒越细小，液相率越高；当保温时间为30 min 时，固 相颗粒球化最好、最均匀。 关键词：应变诱发熔化激活法(SIMA) ；工艺参数；7075 铝合金；半固态显微组织 DOI: 10.14158/j. cnki. 1001-3814. 2015. 11. 006 中图分类号： 文献标识码： 文章编号： TG316; TG146.2 A 1001-3814(2015)11-0022-03 Effects of SIMA Process Parameters on Microstructures of Semi-solid 7075 Aluminum Alloy LI Chunxiao, ZHAO Dan, ZHENG Xiaoping, TIAN Yaqiang, SONG Jinying, CHEN Liansheng ( School of Metallurgy and Energy, Hebei United University, Tangshan 063009, China ) ： Abstract 7075 aluminum alloy semi-solid blanks were prepared by the strain-induced melt activation technology (SIMA). Effects of the deformation degree, heating temperature and holding time on microstructures of 7075 aluminum alloy semi-solid blanks were studied separately. The results show that the greater the degree of deformation is, the higher the recrystallization nucleation rate is, and the more uniform and the finer the solid particles of semisolid are. The higher the semi-solid heating temperature is, the finer the solid particles of semi-solid are, and the higher the liquid fraction is. When the holding time is 30 min, balling of the solid particle is the best and the most uniform. Key words ： strain-induced melt activation technology (SIMA); process parameters; 7075 alumin