5000PCTC螺旋浆安装工艺(OK).docVIP

5000PCTC汽车滚装船 文件号: TCN120P(ZS)-400- GY 006 标记 数量 修改单号 签字 日期 Installation procedure of propeller 螺旋桨安装工艺 编制 杨家结 校对 审核 共 11 页 第 1 页 标检 舟 山 中 远 船 务 设 计 部 审定 Purpose The purpose of this guideline workmanship is to ensure procure nicety axial push-up distance and thrust force of the propeller, ensure greating installtion on its position. Range of application This procedure is applied to installtion of the propeller for 5000 PCTC. Data and document ☆ SC4484-103-07 Propeller plan ☆ SC4484-401-07JS Calculation for propeller keyless fitting ☆ TCN120-425-03B Propeller shaft ☆TCN120P-425-02-0A Stern tube assembly Technical parameter Name dia. (mm) Taper hole Φ(mm) Length (mm) weight (kg) Taper ratio propeller Φ6100 Φ585/Φ525 － 22500 1:20 Propeller shaft Φ585 － 8483 21000 Frock Equipment No. NAME QU’T UNITS REMARK 1 Manual oil pump and hosepipe, connection unit, pressure guage etc. 2 sets 2 Oil storage tank(abt.10L) and hyd. Oil 1 sets 3 Micrometer with magnetic holder 3 pcs 4 Point thermometer 1 pcs 5 Lifting equipment（e.g. manual cucurbit etc.） Preparation condition before push-up The propeller shaft were a niced match for the propeller have finished machining matching, and submit it to owner and surveyor for approved. Bolts hole of the big end propeller have bore use to mounting pressplate. To make sure the working safely and conveniently, there is an working platform with the railing、ladders etc to be built nearby the stern from basic line abt. 3m. Lifting eyes for propeller to be checked and welded at proper position on hull structure. Lifting devices and fittings have been checked and prepaied etc. There is no any job casing the strong vibration of concerned hull structure. Application After carefully cleaning all touching surface and oil passages inside propeller hub and shaft by using compressed air,the touching surface to be painted with lubrication oil which is the same as hydraul