Chartek7施工工艺(英文).doc

The procedures for coating application/repair of Chartek7 on the C platform project PL19-3 II 一、 Scope This coating systems and the procedures on coating application is applicable to the steel structure surface treatment, protective coating and the fireproofing coat application. This procedures is established according to the demand of this project Tech. Spec. and the products manual of Akzo Nobel protective coatings, this guidance can not instead of the above document, but it is the reinforce explanation or the detail description. We will modify the segment with correlation in this procedures if the protective coating system of this project is changed. 二、Protective coating systems and fireproofing coating systems 1. Protective coating/ Fireproofing coating systems Coat paint type The ratio of A To B Vol) thinner the ratio of dilution WFT μm DFT μm Mesh position Metal/HK-1 Primer Interzinc52 4:1 GTA220 5-10% 127 50-75 The Sealer Intergard269 4:1 GTA220 5-10% 85 40 Fireproofing coating systems A (A-60) Chartek7 2.44:1 GTA822 NO 5 000 5 000 HK-1 at mid-depth Fireproofing coating systems B (H-60) * Chartek 7 2.44:1 GTA822 NO 10,000 10, 000 HK-1 at mid-depth Fireproofing coating systems C (H-60) Chartek 7 2.44:1 GTA822 NO 13 000 13 000 HK-1 at mid-depth Finish coating Interthane 990 17.14:3.7 GTA 733 5-10% 88-132 50-75 Standard Total DFT A—5140-5190 B—10140-10190 C—13I50-13190 Notice: 1. It must be pre-painting with brush before each layer coat. 2. The part that no-coat by the design or the 100mm area that being ready to weld seal, Please don＇t paint. 3. The paint operator makes the paint application successfully and has the best coating effect by properly adjusting the dosage of the thinner according to the actual case about spray-engine, the pressure of the air be compressed, the condition of the climate. 4. Primer and the sealer the thickness is MAX 110?m. 5. *: DNV (Det Norske Veritars) accept H-60 class s