gcc参数高级应用.docxVIP

Gcc参数高级应用Gcc对ARM的优化/onlinedocs/gcc/ARM-Options.htmlARM OptionsThese `-m options are defined for Advanced RISC Machines (ARM) architectures: -mabi=nameGenerate code for the specified ABI. Permissible values are: `apcs-gnu, `atpcs, `aapcs, `aapcs-linux and `iwmmxt. -mapcs-frameGenerate a stack frame that is compliant with the ARM Procedure Call Standard for all functions, even if this is not strictly necessary for correct execution of the code. Specifying -fomit-frame-pointer with this option will cause the stack frames not to be generated for leaf functions. The default is -mno-apcs-frame. -mapcsThis is a synonym for -mapcs-frame. -mthumb-interworkGenerate code which supports calling between the ARM and Thumb instruction sets. Without this option, on pre-v5 architectures, the two instruction sets cannot be reliably used inside one program. The default is -mno-thumb-interwork, since slightly larger code is generated when -mthumb-interwork is specified. In AAPCS configurations this option is meaningless. -mno-sched-prologPrevent the reordering of instructions in the function prolog, or the merging of those instruction with the instructions in the functions body. This means that all functions will start with a recognizable set of instructions (or in fact one of a choice from a small set of different function prologues), and this information can be used to locate the start if functions inside an executable piece of code. The default is -msched-prolog. -mfloat-abi=nameSpecifies which floating-point ABI to use. Permissible values are: `soft, `softfp and `hard. Specifying `soft causes GCC to generate output containing library calls for floating-point operations. `softfp allows the generation of code using hardware floating-point instructions, but still uses the soft-float calling conventions. `hard allows generation of floating-point instructions and uses FPU-specific calling conventions. The default depends on the specific target configuration. Note that the hard-float and