MC9S12飞思卡尔单片机的nRF905无线发射接收程序代码.docVIP

基于MC9S12飞思卡尔单片机的nRF905无线发射接收程序代码——绝对可用 无线发射程序代码： Main()函数代码： #include hidef.h #include derivative.h #include nRF905.h #define uint unsigned int #define uchar unsigned char char i; /********设置锁相环时钟*******/ void PLL_init(void) { CLKSEL=0X00; //disengage PLL to system PLLCTL_PLLON=1; //turn on PLL SYNR =0xc0 | 0x02; REFDV=0x80 | 0x01; POSTDIV=0x00; //pllclock=2*osc*(1+SYNR)/(1+REFDV)=24MHz; _asm(nop); //BUS CLOCK=24M _asm(nop); while(!(CRGFLG_LOCK==1)); //when pll is steady ,then use it; CLKSEL_PLLSEL =1; //engage PLL to system; } void IOkou(void) { DDRA=0XDD; DDRB=0XFF; DDRE=0XFF; //PORTB=0XFF; } void main(void) { PLL_init(); IOkou(); EnableInterrupts; ini_system(); TXsetmode(); for(i=0;i4;i++) { Txbuf[i]=shuju[i+2]; } while(1) { Txpacket(); } } nRF905.h头文件程序代码： uchar shu1,shu2,shu3,shu4; /*******************定义命令字**********************/ #define WC 0x00 // Write configuration register command #define RC 0x10 // Read configuration register command #define WTP 0x20 // Write TX Payload command #define RTP 0x21 // Read TX Payload command #define WTA 0x22 // Write TX Address command #define RTA 0x23 #define RRP 0x24 /***********管脚配置*********/ #define MOSI PORTA_PA6 #define CSN PORTA_PA7 #define SCK PORTA_PA0 #define MISO PORTA_PA1 #define TRX_CE PORTA_PA2 #define TXEN PORTA_PA3 #define PWR PORTA_PA4 #define DR PORTA_PA5 uchar shuju[10]={0x00,0x80,0x40,0xc0, 0x20,0xa0,0x60,0xe0, 0x10,0x90}; uchar Txbuf[4];//shu1,shu2,shu3,shu4 //uchar Rfconfig[10]={0x4c,0x0e,0x44,0x04,0x04,0xe7,0xe7,0xe7,0xe7,0xde}; uchar Rfconfig[10]={0x32,0x70,0x22,0x20,0x20,0xe7,0xe7,0xe7,0xe7,0x7b}; /************延时函数************/ void delay(uint n) { while(1) { n--; if(n=0) { break; } } } /************写入函数