限流孔板说明书汉英.docVIP

目 录 Catalogue 产品用途 Service 产品型式和组成 Component Part 产品成套及使用 Model and Main Performances 产品运输和贮存 Transportation and Storage 随箱技术资料 Attachment in Package Box 订货须知 Information for Placing Orders 一、产品用途 FUNCTION FOR RO LGX型限流孔板也称减压孔板，主要用于流体要求降压的场合。如：在控制阀后设置限流孔板，以减小阀上的压降，降低阀的噪音，减少阀芯阀座的磨损等；流体需要降压及对降压准确度要求不高的场合；或设在控制阀旁路上，以防止手动操作旁路阀时造成泻压太快或发生液位抽空等危险，以及在配管放空系统中降低噪声等等。 LGX RO is also can be called as pressure-reduced orifice, which is mainly used on the site of pressure-loosed requirement. For example, installing RO on the back of control valve so that reducing the pressure and lower the noise of valve, at the same time protecting the valve seat and pith. If you need to loose the flow pressure or avoid quick pressure –lose and liquid –empty, the best choice is using RO, thus you can also reduce the noise of pipeline. 二、产品型式和组成 SCORE AND COMPOSE 限流孔板可分为单级降压和多级降压限流孔板组。其降压级数需根据流体介质、降压要求等参数经计算确定。 Now, we can provide various RO, for example, mono or multi-pressure lose type, the pressure lose class is decided by the fluid and pressure difference. Use single restriction orifice plate when differential pressure is less than 2.5MPa ,otherwise multiplicate restriction orifice plate should be taken 1 三、产品成套及使用 STRUCTURE AND USING METHOD 1.产品成套分为 STRUCTURE DETAIL 1)单级限流孔板装置 MONO-PRESSURE LOSE RO a)单板：只提供孔板(按用户提供法兰标准及密封面型式配置)。 The orifice plate (only offer the plate, which is produced according to the flange and seal type of customer) b)单级成套：含孔板、紧固用法兰、密封垫片及螺栓组件。 The unit include: orifice plate, flange for tight, seal shim and bolts and nuts 2)多级降压限流孔板组装置 MULTI-PRESSURE LOSE RO a)法兰连接式限流孔板组件：此种供货不提供密封垫片及螺栓组等。 Flange type RO include: seal shim, bolts and nuts are not included in this type of RO b)带工艺法兰限流孔板组装置：成套含限流孔板组、工艺配对法兰、密封垫片及螺栓组等。 RO with the technology flange: which include orifce plate units, seal shim and bolts and nuts. Fig.1 多级限流装配示意图(RF)Diagram of multiplicate restriction orifice plate equipment (RF) 2 螺栓组 Bolts and nuts 工艺法兰 Processing flange 本体法兰 F