单片机温度测控仪课程设计程序.docVIP

单片机温度测控仪课程设计程序 //与试验箱的接线方式在程序中有说明，看懂即可连接成功 #includereg52.h /*p0读AD，p1段选p2,键盘，p3前四位控位选，后四位控制线*/ sbit wr=P1^4; sbit rd=P1^5; //sbit cs=P3^2; sbit eoc=P1^6; //sbit a0= P3^0 ; //此三位为模拟通道地址选择，由于I/O资源不足，此处将其直接接地，后面读AD子函数中也已屏蔽地址选择的操作 //sbit a1= P3^1; //sbit a2= P3^2; sbit bell= P1^7;//此处为调试设定，实际运行时应修改 //sbit lock=P3^5; sbit wei0=P1^0; sbit wei1=P1^1; sbit wei2=P1^2; sbit wei3=P1^3; //p2段选 sbit dp=P2^7; unsigned char zhutai,shezhi; unsigned char up,down; unsigned char AD_result; unsigned char readtemp(); //滤波子函数，200点平滑滤波 unsigned char scanf_key() ; //扫描键值 void scanf_command(); //扫描指令，做出响应 unsigned char move(unsigned char x); //状态切换 void send(unsigned char add , unsigned char num,unsigned char dat); //数码管下载子函数 void delay(unsigned int xms); //延时子函数 void init(); //初始化 unsigned char readAD(); //读AD void playtemp(unsigned char wen); //显示温度值，将AD结果转换为温度值，包含转换算法 unsigned char code zi[]={0x3f,0x06,0x5b,0x4f,0x66,0x6d,0x7d,0x07,0x7f,0x6f,0x40,0x00};//段编码数组 void send(unsigned char add , unsigned char num ,unsigned char dat) { P2=zi[num]; switch (add) { case 0: { wei0=1; wei1=0; wei2=0; wei3=0; } break; case 1: { wei1=1; wei0=0; wei2=0; wei3=0; } break; case 2: { wei2=1; wei0=0; wei1=0; wei3=0; } break; case 3: { wei3=1; wei0=0; wei1=0; wei2=0; } break; } if(dat==1) dp=1; else dp=0; } void delay(unsigned int xms) { unsigned int i,j; for(i=xms;i0;i--) { for(j=110;j0;j--); } } void init() { bell=0; zhutai=0; shezhi=0; up=30; down=10; wr=1; rd=1; // cs=0; AD_result=0; } unsigned char readAD() { unsigned char AD_value=0; // a0=0; // a1=0; // a2=0; wr=0; wr=1; rd=0; //调试时若有问题可以考虑在此处增加delay(1);指令 while(eoc); AD_value=P0; rd=1; return AD_value; } unsigned char scanf_key() { unsigned char temp,key_value; key_value=20; P3=0xfe; temp=P3; temp=temp0xf0; if(temp!=0xf0) { de