Catalyst 3500基本配置.doc

直接进入默认的VLAN 1中进行配置命令如下：interface VLAN1ip address 172.16.1.3 255.255.0.0即可。在Catalyst 中控制对Telnet的访问bluestudy_a(config)#access-list 2 permit 172.16.0.0 0.0.255.255 （定义标准的访问列表）bluestudy_a(config)#line vty 0 15（进入telnet端口，最多允许16个telnet的会话）bluestudy_a(config-line)#access-class 2 in（应用上述定义的访问列表，即只有172.16.0.0/16的网段可以实现对交换机的telnet会话设置交换机的enable 密码bluestudy_a(config)#enable password bluestudybluestudy_a(config)#enable secret bluestudyThe enable secret you have chosen is the same as your enable password.This is not recommended. Re-enter the enable secret.注：对于如上的密码，secret的优先级更高，优先起作用。设置console口密码bluestudy_a(config)#line con 0bluestudy_a(config-line)#password bluestudybluestudy_a(config-line)#设置对telnet的密码：bluestudy_a(config)#line vty 0 15bluestudy_a(config-line)#loginbluestudy_a(config-line)#password bluestudybluestudy_a(config-line)#设置登陆用户名和密码：bluestudy_a(config)#username bluestudy password bluestudybluestudy_a(config)#bluestudy_a#show runningCurrent configuration:!version 12.0no service padservice timestamps debug uptimeservice timestamps log uptimeno service password-encryption!hostname bluestudy_a!enable secret 5 $1$b1mb$p6XgV/PY9WqvJy9MrHZFG/enable password bluestudy!username bluestudy password 0 bluestudy!ip subnet-zero!interface FastEthernet0/1!interface FastEthernet0/2!interface FastEthernet0/3!interface FastEthernet0/4!interface FastEthernet0/5!interface FastEthernet0/6!interface FastEthernet0/24!interface GigabitEthernet0/1!interface GigabitEthernet0/2!interface VLAN1ip address 172.16.1.3 255.255.0.0no ip directed-broadcastno ip route-cache!access-list 2 permit 172.16.0.0 0.0.255.255!line con 0password bluestudytransport input nonestopbits 1line vty 0 4access-class 2 inpassword bluestudyloginline vty 5 15access-class 2 inpassword bluestudylogin!endbluestudy_a# [page]port channel 与 Spanning tree连接的区别bluestudy_a(config)#interface fastEthernet 0/1bluestudy_a(config-if)#port gro