注塑模具设计指导--外國工程師傳授的design資料.docVIP

外國工程師傳授的design資料，供大家享受。9s0l#ffb$Z K[HInjection Molding Design Guidelines CAD/CAM/CAE综合资讯网站论坛i3xxIoM0MBbt5L www.iCA]u{1mMuch has been written regarding design guidelines for injection molding. Yet, the design guidelines can be summed up in just a few design rules. 已经有许多关于设计注塑模具的书了,但是设计准则可以被概括以下几点:\U)J9L7^CAD,CAE,CAM,ICAX,idesign,模具,设计,招聘,培训iCAx开思论坛9m$|h9VAhUse uniform wall thicknesses throughout the part. This will minimize sinking, warping, residual stresses, and improve mold fill and cycle times. n
?dH%`3dI,}Use generous radius at all corners. The inside corner radius should be a minimum of one material thickness. 2.在转角处大量采用圆角.圆角内部最小半径为一个壁厚.({r8] rY5b$J Ywww.iCA9J1S,n;WT? ? ? ? u
nvx(~5VUse the least thickness compliant with the process, material, or product design requirements. Using the least wall thickness for the process ensures rapid cooling, short cycle times, and minimum shot weight. All these result in the least possible part cost. www.iCA3[G+d ^\ W3.根据工艺,材料,产品设计需求.采用最小壁厚.最小壁厚的应用可以确保快速的冷却,短循环时间和减少喷射重量.所有这些最终达到最小的产品成本.2u4H8D(t:PV] ZpeCAD,CAE,CAM,ICAX,idesign,模具,设计,招聘,培训Design parts to facilitate easy withdrawal from the mold by providing draft (taper) in the direction of mold opening or closing. CAD/CAM/CAE综合资讯网站论坛4l6Z7v.V2jQ0G%~*P:r(Z`? ? ? ? yUse ribs or gussets to improve part stiffness in bending. This avoids the use of thick section to achieve the same, thereby saving on part weight, material costs, and cycle time costs. 5.为了提高产品强度抵抗弯曲应该加筋或肋.避免用厚的结构达到同样的效果,以此减少了产品重量,材料成本,循环时间成本. The use of ribs iCAx开思论坛8o.y+p-p? ? ? ? t*CJ9x4LbP#HRibs increase the bending stiffness of a part. Without ribs, the thickness has to be increased to increase the bending stiffness. Adding ribs increases the moment of inertia, which increases the bending stiffness. Bending stiffness = E (Youngs Modulus) x I (Moment of Inertia) 如果没有筋来增加强度,厚度就必须增加(费话一堆).加强筋增加了转动惯量!y%V-`dEg{Zswww.iCAl)OeCVCThe rib thickness should be less t