厚油层层内深部堵水工艺技术研究与试验.docVIP

厚油层层内深部堵水工艺技术研究与试验 于永生 邹小萍 刘伟 代晋光 曹作为 于浩洋 大港油田石油工程研究院 大港油田第六采油厂 X 关注成功！ 加关注后您将方便地在 我的关注中得到本文献的被引频次变化的通知！ 新浪微博 腾讯微博 人人网 开心网 豆瓣网 网易微博 摘????要： 针对厚油层层内堵水技术存在有效率低、有效期短的问题, 以高强度层内深部堵水技术研究为出发点, 研究了用于油层深部封堵的颗粒溶胶高强度堵剂、用于近井地带封堵的暂堵型高强度堵剂以及层内堵水的优化设计方法。室内研究表明, 颗粒溶胶堵剂的封堵强度大于5 MPa, 暂堵型高强度堵剂的抗压强度大于20MPa, 漏失量与水泥类堵剂相比下降40%以上;现场试验表明, 研究的层内堵水工艺可大幅降低油井产水, 提高油井产量, 堵水有效期达到1 a以上。 关键词： 层内深部堵水; 堵水工艺参数优化; 颗粒溶胶堵剂; 暂堵型高强度堵剂; 作者简介：于永生 (1968-) , 男, 高级工程师, 研究方向:调剖堵水技术及其应用。E-mail:1939028541@ 收稿日期：2017-05-25 基金：国家科技重大专项“大型油气田及煤层气开发” (2011ZX05058) Research and Test of Deep Water Plugging Technology in a Thick Oil Layer YU Yongsheng ZOU Xiaoping LIU Wei DAI Jinguang CAO Zuowei YU Haoyang Research Institute of Petroleum Engineering, Dagang Oilfield; The Sixth Oil Production Plant, Dagang Qilfield; Abstract： The water plugging technology for thick oil layers has low efficiency and short validity period. For this reason, the highstrength particle sol water plugging agent for the deep water plugging of oil reservoir and the high-strength temporary plugging agent for the water plugging of near wellbore area were developed, and the optimization design of in-layer water plugging technology was studied.Laboratory research shows that, the plugging strength of the high-strength particle sol water plugging agent is higher than 5 MPa, the compressive strength of the high-strength temporary plugging agent is higher than 20 MPa, and comparied with cement water plugging agents, their leakage decreases by more than 40%. Field test shows that the studied in-layer water plugging technology can greatly reduce the water production of oil wells and improve the oil production of oil wells, and the water plugging validity period of the technology is more than 1 a. Keyword： deep water plugging in stratum; optimization of water plugging technology parameter; particle sol water plugging agent; high-strength temporary plugging agent; Received： 2017-05-25 于永生, 邹小萍, 刘伟, 等.厚油层层内深部堵水工艺技术研究与试验[J].西安石油大学学报 (自然科学版)