SASO 1257检验报告模式(水箱).docVIP

№：S***** TEST REPORT Tested products: ********* Consignment: ********* Manufacturer: ********* Issued Date: ********* Test laboratory: Xianyang Supervision Testing Center of Architecture Sanitary Ceramics. China №：S ****** 1 of 5 CLIENT’S INFORMATION: Consignment: ********* Consignment’s address: ********* Manufacturer: ********* Manufacturer’s address: ********* SAMPLE DESCRIPTION: Product: ****** Trade mark: **** Amount of samples: * sets Model: **** Produce date: --/--/(dd/mm/yy) Other description: －□high-level flushing water tank □close-coupled flushing water tank －□cast iron □ceramic ware □vitreous china □pressed steel □plastic －□concealed flushing water tank □exposed plastic water tank SOURCE OF SAMPLES: The sample was transport to the CQTC by truck, from ******. The sample was received in good condition on May **, 2011. DATE OF TESTING: May **, 2011 ~ May **, 2011 TEST REQUESTED: SASO (Saudi Standard No.) 1257/1998 Sanitary Appliances: Flushing Water Tanks CONCLUSION: The sample tested complied with the applicable section of SASO (Saudi Standard No.) 1257/1998 Sanitary Appliances: Flushing Water Tanks.［The sample tested complied with the section required by consignment of SASO (Saudi Standard No.) 1257/1998 Sanitary Appliances: Flushing Water Tanks, except for section *.*, *.* and *.*.］ Evaluated by Reviewed by Test engineer. Manager of the lab. Issued date: May **, 2011 Note: 1.This report may not by copied, except copy it entirety and got a written permission of CQTC. 2. The inspection results are only responsible for the tested sample. №：S ******