CCNA纠错题目.docVIP

Question 258: Refer to the exhibit. Which switch provides the spanning-tree designated port role for the network segment that services the printers? A.Switch1 B.SWitch2 C.Switch3 D.Switch4 提供指定端口的是switch3 C Question 266: Refer to the exhibit.Given the output from the show ip eigrp topology command, which router is the feasible successor?   feasible successor条件：ADFDFD确定选B Refer to the exhibit. What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown? A: The Serial0/0 interface is passing traffic. B: The DLCI 100 was dynamically allocated by the router. C: The Serial0/0 interface acquired the IP address of from a DHCP server. D: The DLCI 100 will be dynamically changed as required to adapt to changes in the Frame Relay cloud. E: The mapping between DLCI 100 and the end station IP address was learned through Inverse ARP. E 这道题lowest的话是反的第一步为cable yiyang 题干的意思是：启动一台路由器的时候，端口不断由down变为UP（F0/1,F0/2,F0/11,F0/12...）但，vlan1变为down.问会什么情况？答案就选 如果不重新修改路由器配置的话，将不能远程访问该路由器。Refer to the exhibit. For what two reas** has the router loaded its IOS image from the location that is shown?(Choose two) 8.JPG (34.35 KB) 2010-3-23 22:59 A.Router1 has specific boot system commands that instruct it to load IOS from TFTP server. B.Router1 is acting as a TFTP server for other routers. C.Router1 cannot locate a valid IOS image in flash memory. D.Router1 defaulted to ROMMON mode and loaded the IOS image from a TFTP server. E.Cisco routers will first attempt to load a image from TFTP for management purposes. A C to implement VTP. Both switches are configured as VTP servers in the same VTP domain. VLANs added to Switch1 are not learned by Switch2. Based on this information and the partial configurati** in the exhibit ..what is the problem? 7.JPG (56.81 KB) 2010-3-23 22:59 A.Switch2 should be configured as a VTP client. B.VTP is Cisco proprietary and requires a different trunking encapsulation. C.A router is required to ro