Cisco设备硬件检测.docx

设备硬件检测分为设备电源状态检测、设备风扇状态检测、设备温度状态检测。工作内容：对用户需维护的设备现场进行勘察，通过在CLI状态下使用系统的诊断命令检测设备的电源状态、风扇状态及温度状态。检测方法及步骤考虑到Cisco设备的型号及系统平台分类较多，其检测的方法也有不同，以下将安装不同的网络设备系统平台，分别说明具体的检测方法及步骤。一　Cisco Catalyst6500 CatOS, C4000 CatOS系列交换机注：Cisco Catalyst6500,C4500，C4000系列交换机分CatOS和NativeIOS两种版本，系统提示符类似于Catalyst6509 (enable) 、Catalyst4006 (enable)的为CatOS, 系统提示符类似于C6509# 、C4507R#　的为NativeIOS。　电源状态检测对于Cisco Catalyst6500, C4000系列交换机, 在enable模式下可以用以下命令检测电源状态：show systemshow environmentshow environment power例：show systemCatalyst6509 (enable) show system PS1-Status PS2-Status ---------- ---------- ok ok Fan-Status Temp-Alarm Sys-Status Uptime d,h:m:s Logout---------- ---------- ---------- -------------- ---------ok off ok 9,21:34:43 20 minPS1-Type PS2-Type-------------------- --------------------WS-CAC-1300W WS-CAC-1300W Modem Baud Traffic Peak Peak-Time------- ----- ------- ---- -------------------------disable 9600 0% 5% Fri Jul 23 2004, 17:39:44PS1 Capacity: 1153.32 Watts (27.46 Amps @42V)PS2 Capacity: 1153.32 Watts (27.46 Amps @42V)PS Configuration : PS1 and PS2 in Redundant Configuration.System Name System Location System Contact CC------------------------ ------------------------ --Catalyst6509注：做红色标注的为检测时对于系统输出的关注点。show environmentCatalyst6509 (enable) show environment Environmental Status (. = Pass, F = Fail, U = Unknown, N = Not Present)PS1: . PS2: . PS1 Fan: . PS2 Fan: .Chassis-Ser-EEPROM: . Fan: .Clock(A/B): A Clock A: . Clock B: .VTT1: . VTT2: . VTT3: .show environment powerCatalyst6509 (enable) show environmen powerPS1 Capacity: 1153.32 Watts (27.46 Amps @42V)PS2 Capacity: 1153.32 Watts (27.46 Amps @42V)PS Configuration : PS1 and PS2 in Redundant Configuration.Total Power Available: 1153.32 Watts (27.46 Amps @42V)Total Power Available for Line Card Usage: 1153.32 Watts (27.46 Amps @42V)Total Power Drawn From the System: 441.42 Watts (10.51 Amps @42V)Remaining Power in the System: 711.90 Watts (16.95 Amps @42V)Default Inline Power allocation per port: 7.00 Watts (0.16 Amps @42V)Slot powe