弯管工艺国外研究现状.docVIP

【1】 S. Baudin, P. Ray, B.J. MacDonald. Development of a novel method of tube bending using finite element simulation, Journal of Materials Processing Technology, 2004, 153-154: 128-133. 研究聚氨酯芯棒情况下，弯管的起皱、横截面形状变化及应力应变分布。 The geometry of the model was easily developed using the ANSYS pre-processing tools. In this case simulations were carried out to produce a 90? bend in a straight tube of inner diameter 37.6 mm, outer diameter 40mm and length 140 mm. The die had an inner radius of 40mm and a die bend radius of 70 mm. The outer diameter of the urethane rod was 37.6mm and its length was 140 mm. The meshed die, tube and rod geometry’s are shown in Fig. 2. 【2】 Y. Zhang, D. Redekop. Shell element simulation of the push method of tube bending, Journal of Archievements in Materials and Manufacturing Engineering, 2006, 17(1-2): 301-304. 研究弯管过程，弯曲半径、材料类型、摩擦参数等的变化对弯管质量的影响规律。 A parametric study is then carried out, giving results for a number of variations in the forming process, including geometry, material properties, and lubrication parameter, and finally conclusions are drawn. 【3】 H. A. Al-Qureshi. Elastic-plastic analysis of tube bending, International Journal of Machine Tools and Manufacture, 1999, 39(1): 87-104. 对弯制工艺采用解析方法（弹塑性分析）分析弯管的回弹，并与试验进行对比。 【4】 Z. Hu, J.Q. Li. Computer simulation of pipe-bending processes with small bending radius using local induction heating, Journal of Materials Processing, 1999, 91(1-3): 75-79. Z. Hu. Elasto-plastic solutions for springback angle of pipe bending using local induction heating, Journal of Materials Processing Technology, 2000, 102(1-3): 103-108. 解析法计算局部感应加热数控弯管回弹 X.T. Li, M.T. Wang, F.S. Du. FEM Simulation of Large Diameter Pipe Bending Using Local Heating, Journal of Iron and Steel Research International, 2006, 13(5): 25-29. To investigate the process parameters of pipe-bending using local induction heating with a small bending radius so as to control the whole process, a computer simulation system has been set up based on the