最新版出口模具标准 Rev B(2011-6-2).docVIP

K-Rain General Injection Tool Standards （科雨一般注塑模具標准） Stanley Hsia WeiYa Mould Co., Ltd. Bu Bu Gao Da Dao Wu Sha Jiang Bei Vil. Chang An Town, Dongguan City, Guangdong Prov. China Tel: 0769Fax: 0769PURCHASE ORDER #EPO-3423(訂單編號#EPO-3423) This purchase order is issued to the WeiYa Mould Co. Ltd. to tool a four (4) cavity stainless steel mold to produce the Director, Flow Control, K4, 1400402-10 of K-Rain Manufacturing Corp. 此PO下給威亞模具有限公司，向威亞公司訂購一套4穴的不锈鋼模具, 科雨將用該模具生產Director, Flow Control, K4, 1400402-10 Material for the Director, Flow Control, K4, 1400402-10 is Black ABS. 流量控制器的材質請用黑色ABS料. Target cycle is 22 seconds. 目標周期為22秒. Cavity I.D. starts from 1 to 4. 穴號從1至4. Cav. I.D. and P/N need to be engraved on the part. 穴數I.D號和P/N需雕刻在產品上. CONFIDENTIALITYand NON-COMPETE Obligation (保密性和不正當竞爭): A confidentiality agreement applies to the purchase order. Confidential information shall mean any information disclosed to WeiYa Mould Co., Ltd. by K-Rain and that is clearly marked or otherwise designated as “confidential”, or if disclosed orally, is identified as confidential at the time of disclosure. Confidential information shall be deemed to include, but not be limited to, any and all technical information, trade secrets, inventions (whether or not patentable), know-how, specifications, designs, methods, practices, procedures, processes, developments, manufactures, or assembly of the products subject to this agreement and any component or part thereof. The WeiYa Mould Co., Ltd. agrees to maintain all confidential information in trust and confidence and not to disseminated or disclose any third party. WeiYa Mould Co., Ltd. agrees not to use the confidential information except as necessary to accomplish the purpose of this specific contract (the Contract) for K-Rain. WeiYa Mould Co., Ltd. agrees that it shall disclose confidential information only to those employees or agents who need to know such information in order to accomplish the purpose of the Contr