上汽通用别克汽车维修手册-sect12Cvu.pdfVIP

SECTION 12C - INSTRUMENTS, WIPERS/WASHERS HORN IMPORTANT: Before performing any Service Operation or other procedure described in this Section, refer to Section 00 CAUTIONS AND NOTES for correct workshop practices with regard to safety and/or property damage. 1. GENERAL INFORMATION The instruments, wipers/washers and horn fitted to VU Series Models carry over from VX Series Models, noting the following: • VU Series Models with V6 engine and manual transmission have a final drive ratio of 3.46:1, requiring a unique speedometer calibration. • VU Series Models are fitted with a new fuel tank and sender configuration, requiring a unique fuel level gauge calibration. For information relating to the Instruments, Wipers/Washers and Horn fitted to VU Series Models not covered in this Section, refer to Section 12C INSTRUMENTS, WIPERS/WASHERS HORN in the VX Series Service Information in conjunction with Section 12C INSTRUMENTS, WIPERS/WASHERS HORN in the VT Series I and VT Series II Service information. 2. SERVICE OPERATIONS The service operations for instruments, wipers/washers and horn as fitted to VU Series Models carry over from VT Series I and VT Series II Models, noting the following: • Removal and reinstallation procedures for the instrument cluster as fitted to VU Series Models carry over from the VT Series I, refer to Section 12C – INSTRUMENTS, WIPERS/WASHERS HORN in the VT Series I Service Information. However, the instrument configuration and fuel level gauge calibration procedures during the programming of the new instrument cluster is unique. • If the instrument cluster is found to be faulty, the replacement cluster must be programmed following installation.