含V高碳钢的热模拟组织与性能-应用昆虫学报.PDFVIP

下半月出版 Material Heat Treatment 料热处理技术 含V 高碳钢的热模拟组织与性能 黄文克, 麻晗, 胡显军, 周铖 (江苏省(沙钢)钢铁研究院, 江苏 苏州 215625) 摘 要 采用Gleeble-3800 热模拟试验机 结合光学显微镜和扫描电镜 研究了含V 高碳钢在不同Stelmor 控冷条 件下的组织与性能遥 结果显示 对于V 含量为0.15%的高碳钢 在650～590 采用0.55尧1 K/s 的冷却速度 索 化率 均能达到97%以上 硬度均在470 HV 10 以上 但组织中存在少量网状渗碳 曰当V 含量为0.30%时 在650～590 采 用0.55 K/s 的冷却速度 索 化率在97%以上 硬度在490 HV 10 以上 片层间距小于80 nm 网状渗碳 消失遥 当冷 却速度提高到1 K/s 时 组织中出现马 遥 关键词 高碳钢曰热模拟曰微观结构曰力学性能 中图分类号 TG 142.1 文献标识码 A 文章编号 Microstructure and Properties of V-bearing High Carbon Steel HUANG Wenke, MA Han, HU Xianjun ZHOU Cheng (Institute of R esearch of Iron Steel, Suz hou 2 15625, China) Abstract 院The microstructure and properties of V-bearing high carbon steel under different Stelmor cooling parameters were studied by using Gleeble-3800 thermal-mechanical system combining with OM and SEM. The results show that the sorbite fraction above 0.97 and hardness over 470 HV 10 can be obtained for high carbon steel with 0.15%V under the cooling rate of 0.55 K/s or 1 K/s during 650 ℃～590 , but a little cementite network appears. With V increased to 0.30% , the hardness increases to over 490 HV 10 at the same sorbite fraction under the cooling rate of 0.55 K/s during 650 ℃～590 , pearlite lamellar spacing can be refined to be less than 80 nm, while cementite network disappears. However, martensite appears at 1K/s. Key words 院high carbon steel; thermal