LEDArtist软件使用说明(EN).docVIP

LEDArtist operating system instructions LEDArtist Suitable controller card：HD-S1, HD-M1 Hardware description ⅰ.HD-M1 Hardware description（nclude HD-M1A,HD-M1+） ⅱ.HD-S1 Hardware description Ⅱ.LedArtist software description: ⅰ. Main Interface 1.Add Card:Add a new context(card); 2.Settings: Set screen parameter and serial port; 3.Brightless: Brightness control(Have three types:manual operation, autoregulation and Dayparting); 4.Autodown: Timing on/off setting; 5.Adjust Time:Time check and transmitting; 6.New Text:Add a new text item(have special efficiency); 7.Rich Text:Add a new image-text item(can set kinds of font and color); 8.Exit:Exit ⅱ.System setting If you received our LED controller,you must connect the hardware with you computer in the right way. Then you should set the software in sequence ①Add a new context(software acquiesce in a card1) ②Settings: Set screen parameter and serial port; Basic setting: Commands: ⅲ. Brightless: Brightness control(set light adjustment style) Fixedbrightless: Should regulate bye yourself on the fixed brightless; AutoMode: Should add lightdependentresistor; Time seg:Set brightless on the different time; ⅳ. Autodown(Auto turn off,and set non-turn off ,turn off on schedule) ⅴ. Adjust Time:Time check and transmitting ⅵ.New Text:Add a new text item(have special efficiency); Take care:Text program, can provid printing font ,flying font and any other etfcts ⅶ. Rich Text:Add a new image-text item(can set kinds of font and color) Take care: image-text item program:can set kinds of font and color. ⅸ. communications setting(If you can’t communicate you card and computer,you should check you system communication ) Tare care: When the button grow grey,it showthat the communication is failure,and please check the serial port. Eg. If you set the software in the right way,the led display will show your sending contect.And then you can quit the software. Two groups of 08 interfaces,gernerally used indoor of 16 s