IP通信实验报告——RIP.docVIP

IP通信基础实验报告 RIP实验 实验目的 1.掌握在GAR路由器上配置RIP所需的基本命令； 2.掌握RIP的基本原理 实验内容（仿真程序‘路由器RIP.pkt’） GAR路由器的RIP协议配置 实验设备 路由器 3台 PC机 2台 交叉网线 4条 实验拓扑图 配置步骤 RT1===配置底层 --- System Configuration Dialog --- Continue with configuration dialog? [yes/no]: no Press RETURN to get started! Routerenable Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#ho RT1 RT1(config)#interface f RT1(config)#interface fastEthernet 0/0 RT1(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet0/0, changed state to up RT1(config-if)#ip address 192.168.10.254 255.255.255.0 RT1(config-if)#exit RT1(config)#interface fastEthernet 1/0 RT1(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet1/0, changed state to up RT1(config-if)#ip ad RT1(config-if)#ip address 12.12.12.1 255.255.255.0 RT1(config-if)#exit RT1(config)# RT2====配置底层==================================================================================== Continue with configuration dialog? [yes/no]: no Press RETURN to get started! Routerenable Router#conf t Enter configuration commands, one per line. End with CNTL/Z. Router(config)#ho RT2 RT2(config)#interface fastEthernet 1/0 RT2(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet1/0, changed state to up RT2(config-if)#ip address 12.12.12.2 255.255.255.0 RT2(config-if)#exit RT2(config)#interface fastEthernet 1/1 RT2(config-if)#no shutdown %LINK-5-CHANGED: Interface FastEthernet1/1, changed state to up RT2(config-if)#ip RT2(config-if)#ip a RT2(config-if)#ip add RT2(config-if)#ip address 23.23.23.2 255.255.255.0 RT2(config-if)#exit RT2(config)# RT3====配置底层================================================================= Continue with configuration dialog? [yes/no]: no Press RETURN to get started! Routerenable Router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)#ho RT3 RT3(config)#interface fastEthernet 1/1 RT3(config-if)#no shutdown %LINK-5-CHANGED: