机械化搅拌站水泥罐标识方案.docxVIP

孟加拉PAYRA 2×660MW燃煤电厂工程Bangladesh PAYRA 2 x 660 mw coal-fired power plant project搅拌站罐体标识喷漆技术要求Cement tank station logo spraying technical requirements编制： authorized strength： 审核： Reviewers： 批准人员 ： authorizing officer：日期date：搅拌站水泥罐标识喷漆技术要求Cement tank station logo spraying technical requirements关于机械化搅拌站水泥罐体公司标识样式选择。About mechanical mixing station cement tank company logo styles to choose from。1 水泥灌体标识样式如下图所示，标识为双面喷涂。The cement tank logo style as shown in the figure below, identified as double-sided spraying。标识尺寸的确定The determination of logo size根据水泥供货厂家提供的水泥罐体直径确定两个标识为上图样式，尺寸皆为弧面长度3.45m*高度1.5m，上部蓝条高度为1.0m，往下区域喷漆高度依次为2.5m、2.5m、2.5m、2.5mm、1.5m。标识采用罐体两面喷涂，并要求居中喷涂。Determined according to cement tank diameter of the cement supplier provides two logo for above style, size of curve length is 3.45 m * 1.5 m, the top blue bar height of 1.0 m, the area under the spray height of 2.5 m, 2.5 m, 2.5 m, 2.5 mm, 1.5 m. Identification by spraying on both sides of tank, Request center spraying罐体喷涂油漆要求tank spray paint requirements1、喷涂前进行表面处理，无凹坑、无夹层，边沿无毛刺，焊接接头、咬边、凸出处要打磨光滑，钢材表面无锈蚀、酸、碱、油脂等污物。?For surface treatment before spraying, pits, interlining, edge, no burr, welded joint, bite edge, to smooth out, steel rust, acid, alkali, grease and dirt2、结构件表面喷砂除锈等级应达到Sa2.5级，其它部件表面除锈等级必须达到Sa2级。Structure surface sandblasting derusting grade should reach Sa2.5 level, the other part surface descaling grade must achieve Sa2 level?3、油漆干透后漆膜应牢固地粘附在涂面上，不得有发粘、脆裂、脱皮、皱皮、气泡、斑痕及粘附颗粒杂质等缺陷，外观漆膜应均匀、细致、光亮平整、颜色一致，不得有流痕和明显刷痕。After paint dry film adhesion on the coating should be firmly, can not have sticky, embrittlement, peeling, wrinkled skin, bubble, flecked and adhesive particle impurity defects, such as exterior coating should be uniform, delicate, bright, smooth, consistent color can not have flow mark and clear brush marks4、喷涂油漆的标准为底漆两遍、中间漆一遍、面漆两遍，适合防腐要求在20年左右的。Standard for primer spraying paint twice, intermediate paint again, surface paint twice, is suitable for anticorrosion requirements in 20 years or so底漆