基于ATmega8的SD卡读写程序.docVIP

#include iom8v.h #include macros.h typedef unsigned char uchar; typedef unsigned int uint; /*LCD引脚定义*/ #define CS_set PORTD |=BIT(6) #define CS_clr PORTD =~BIT(6) #define SID_set PORTD |=BIT(7) #define SID_clr PORTD =~BIT(7) #define SCLK_set PORTB |=BIT(0) #define SCLK_clr PORTB =~BIT(0) /*SPI总线接口定义*/ //#define SCK_out DDRB |=(15) #define SCK_set PORTB |=(15) #define SCK_clr PORTB =~(15) //#define MISO_in DDRB =~(14) #define MISO_set PORTB |=(14) #define MISO_Re PINB (14) //#define MOSI_out DDRC |=(13) #define MOSI_set PORTB |=(13) #define MOSI_clr PORTB =~(13) //#define SS_out DDRB |=(12) #define SS_set PORTB |=(12) #define SS_clr PORTB =~(12) #define ADDR 512 //SD扇区地址 uchar pbuf[512]; uchar is_init; int Dat; #define DELAY_TIME 500 #define TRY_TIME 200 #define INIT_CMD0_ERROR 0X01 #define INIT_CMD1_ERROR 0X02 #define WRITE_BLOCK_ERROR 0X03 #define READ_BLOCK_ERROR 0X04 void Delay(uint t) { while(t--) {} } void Delayms(uchar a) { while(a--) { Delay(60000); } } /*LCD12232端口初始化*/ void PORT_Init(void) { DDRD |=BIT(6); PORTD |=BIT(6); DDRD |=BIT(7); PORTD |=BIT(7); DDRB |=BIT(0); PORTB |=BIT(0); } /*LCD12232写数据*/ void Send_DATA(uchar Data,uchar O_Z) { uchar i,Order; CS_clr; switch(O_Z) { case 0 : Order=0xf8;break;//写指令 case 1 : Order=0xfa;break;//写数据 default : break; } SCLK_clr; CS_set; for(i=0;i8;i++) { if(Order0x80) SID_set; else SID_clr; SCLK_clr; SCLK_set; Order=1; } Order=Data; Order =0xf0; for(i=0;i8;i++) { if(Order0x80) SID_set; else SID_clr; SCLK_clr; SCLK_set; Order=1; } Order=Data; Order=4; for(i=0;i8;i++) { if(Order0x80) SID_set; else SID_clr; SCLK_clr; SCLK_clr; SCLK_set; Order=1; } CS_clr