扶风县镇污水厂工艺设计_SBR池毕业设计书..doc

毕业设计书一:扶风县镇污水厂工艺设计二:30000m3/d 三:扩初设计和施工图设计四:工艺设计五1?自然状况 扶风县主要属于大陆性半湿润温暖气候,四季分明,雨热同季,年平均日照2090.9h,年平均气温13.3℃,1月份平均气温-0.9℃,7月份平均气温为25.8℃,年平均降雨量580mm ,年平均无霜期218.3d,年冰冻期49天,历年最大冻土深度32mm,常年主导风向东南风,次为西北风2?污水水质 COD=280mg/L,BOD5=180mg/L,SS=300mg/L,PH=7,TN=40mg/L,TP=6mg/L,NH3-N=16mg/L 3?排放标准 污水厂出水水质应符合《城镇污水处理厂污染物排放标准》(GB18918-2002)中地一级A标准地规定,即COD=50mg/L,BOD5=10mg/L,SS=10mg/L,TN=15mg/L,TP=0.5mg/L,NH3-N=5mg/L六1?扩大初步设计文件与图纸 2?施工图设计图纸  扶风县污水处理厂工艺设计 本设计是关中扶风县污水处理厂地扩初设计和施工图设计,此污水处理厂为小型水厂,主要处理城市生活污水,日处理量为30000m3,要求出水水质达到一级A类标准进出水水质COD BOD SS TN TP NH3-N 进水280 180 300 40 6 16 出水50 10 10 15 0.5 5 由于此污水氮,对生物脱氮除磷要求较高,故拟采用SBR污水处理工艺和卡鲁塞尔氧化沟污水处理工艺,经过一系列地技术对比和经济对比,选用SBR污水处理工艺在SBR池与接触消毒池中间设有纤维转盘滤池,以保证出水水质达标 SBR污水处理工艺地核心是SBR池,该池集均化,处理工业废水也无需调节池,污泥易于沉淀,不需设置污泥回流系统通过对运行方式地调节,在单一曝气池内能够进行脱氮和除磷反应应用电动阀,使SBR工艺实现全部自动化,由中心控制运行管理得当,处理水水质优于连续式关键词:SBR生物脱氮除磷 This design is off in Fufeng County sewage treatment plant preliminary design and construction design, this wastewater treatment plant for small waterworks, dealing mainly with municipal sewage, daily processing capacity of 30000m3, required to achieve a Class A water quality standards. Influent, effluent quality comparison COD BOD SS TN TP NH3-N Influent 280 180 300 40 6 16 effluent 50 10 10 15 0.5 5 Because this effluent nitrogen and phosphorus content is relatively high, the proposed sequencing batch reactor activated sludge process (SBR)wastewater treatment process and the Carrousel oxidation ditch sewage treatment process, after a series of technical and economic comparison contrast, the choice of SBR wastewater treatment process. SBR tank and contacts in the middle of a fiber dial disinfection pool filter, in order to ensure water quality standards. The core of SBR wastewater treatment process is SBR pool, the pool is set homogenization, primary sedimentation, biodegradation, and other functions in a secondary sedimentation tank, treatment of industrial waste water without adjustment, sludge easy precipitation,