K1通过版(JIM).docVIP

K1+ 以下解法，不敢保证任何一项满分，但是总够通过K1+的版本分数线 Configure all of the appropriate nontrunking access-switch ports on SW1,SW2,and SW3,according to the following requirements: Configure the VLANs for the access-switch ports show as the vlan table,include the ports BB1,BB2 and BB3. Configure trunk between SW1 F0/2 and R2 G0/1. Make sure that the spanning tree enters the forwarding state immediately. Only for these access switch ports,by passing the listening and learning states. Avoid transmitting Bridge Protocol Data Units(BPDUs) on these access switch ports,if a BPDU is received on any of these ports,the ports should transition back to listening,learning and forwarding states. Add any special Layer 2 commands that are required on the routers including trunk configuration. SW1 should be the root for all vlans and for any new vlan. BB devices must not be in the path to the root bridge. . SW1: spanning-tree vlan 1-4094 root primary SW1/SW2/SW3 Inter f0/10 Span guard root 这是针对BB devices must not be in the path to the root bridge这个需求的解法 SW1\SW2\SW3\SW4: spanning-tree portfast default spanning-tree portfast bpdufilter default 针对“Avoid transmitting Bridge Protocol Data Units(BPDUs) on these access switch ports,if a BPDU is received on any of these ports,the ports should transition back to listening,learning and forwarding states.”这一需求，注意，一定不要用bpduguard 否则bb3的接口会被阻塞掉 Implement Frame relay Use the following requirements to configure R1 and R2 for frame relay and R4 as the Frame Relay switch. Use ANSI LMI on frame relay switch and auto-sesing on R1 and R2. Don’t use any static frame relay maps or inverse address resolutions protocol. Use RFC 1490/RFC2427(IETF)encapsulation. Use the Data-Link Connection Identifier(DLCI) assignments from the table below Frame Relay DLCI assignments ROUTER DLCI R1 Frame-relay interface 100 R2 Frame-relay interface 200 帧中继部分，解法不变 Traffic control protection from the backbones Configure traffic control on the three backbone links,protecting your network from