EMI安规详解.pptVIP

EMI / Safety 观念简介及注意事项;EMI基本概念 简 介;何谓FCC : ;为何必须申请FCC : ;何谓CE : ;何谓电磁干扰 (EMI) : ;何谓电磁免疫 (EMS) :;针对贵公司申请EMI认证,测试项目List :;针对贵公司申请EMI认证,测试项目List :;1. 请特别注意EMS版本, 使用旧版Standard 2001/01/01 已不被欧洲市场所接受. 2. EMI测试法规中文解释: EN55022为Radiation Test Conduction Test (传导幅射测试); EN61000-3-2为Harmonic Test (电源谐波测试) EN61000-3-3为Flicker Test (电压变动测试) 3. EMS测试法规中文解释: EN61000-4-2为ESD Test (静电测试) EN61000-4-3为RS Test (幅射耐受度测试) EN61000-4-4为EFT Test (电子快速脉冲测试) EN61000-4-5为Surge Test (雷击测试) EN61000-4-6为CS Test (传导耐受度测试) EN61000-4-8为PFMF Test (电源频率磁场测试) EN61000-4-11为DIP Test (电压突降测试);FCC Standard Part 15 Section 15.19针对ITE产品规定其Label印刷內容如下 : (1) Class A 自我认证, Label內容必須有以下內容 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Class B DOC 自我认证, Label內容必須有FCC Mark及说明, 如下图 Class B ID认证, Label內容必須有FCC Mark及Class A內容, 如下图 (Label上可以只放FCC Mark, Class A內容放置于Manual中) ;FCC Label 印制內容 :;FCC CLASS A 产品参展注意事项: 根据FCC Part 2 2.805 2.806规定, 未经FCC认可之Class A产品, 参展 时需于展示会上之每一样品明显处贴上以下字句之Label. “ This device has not yet been tested for compliance with FCC rules. This device may not be leased until complacence with Class A limits has been verified.” FCC CLASS B 产品参展注意事项: 根据FCC Part 2 2.803 2.806规定, 未经FCC认可之Class B产品, 参展 时不可提供参考价格或直接于会场报价, 同时须于展示会上之每一样品明显 处贴上以下字句之Label. “The device has not been authorized as required by the rules of the rules of the Federal Communications Commission. This device is not and may not be, offered for sale or lease, or sold or leased, until authorization is obtained.”;;Safety基本概念 简 介;何谓Safety (安规) : ;何谓雷击伤害 : ;何谓能量危险 : ;何谓火灾 : ;何谓机械及热危险 :;何谓辐射伤害 :;何谓化学伤害 :;EMI设计基本概念说明 及注意事项;EMI设计基本概念 :;EMI设计基本概念 :;EMI设计基本概念 :;EMI设计基本概念