C8051F同时实现AD和串口收发的程序.docVIP

C8051F同时实现AD和串口收发的程序//--------------------------------------------------------------------- #include C8051F020.h #include stdio.h sfr16 TMR3RL = 0x92; //定时器3重装载寄存器 sfr16 TMR3 = 0x94; //定时器3计数器 sfr16 DP =0x82; sfr16 ADC0 =0xbe; sfr16 ADC0GT =0xc4; sfr16 ADCOLT =0xc6; sfr16 RCAP2 =0xca; sfr16 T2 =0xcc; sfr16 RCAP4 =0xe4; sfr16 T4 =0xf4; sfr16 DAC0 =0xd2; sfr16 DAC1 =0xd5; #define uchar unsigned char #define uint unsigned int //---------------------------------------------------------------------- //参数设置区 //---------------------------------------------------------------------- #define BAUDRATE 9600 //波特率bps #define SYSCLK//外部晶振,修改也要修改OSCXCN #define SMODVAL 0 //SMOD的值,修改请也修改PCONVAL #define PCONVAL 0x00 //PCON的值,=0x00时SMOD0=0; =0x80时SMOD0=1 #define TXVAL (256-SYSCLK*(SMODVAL+1)/BAUDRATE/384) //定时器初值 #define MAX_LEN 1//每次接收/发送字符串的长度 #define SAMPLERATE0 5000 #define NUM_SAMPLES 1 #define TURE 1 #define FALSE 0 //--------------------------------------------------------------------- //全局变量 //--------------------------------------------------------------------- sbit LED = P1^6; //LED 1亮 0灭 bit readFlag = 0; //读标志 uchar readCounts = 0; //已经读取的字符个数,与MAX_LEN比较 uchar idATa trdATa[MAX_LEN]; //要接收/发送的字符串 xdATa unsigned samples[NUM_SAMPLES]; bit ADC0_DONE; //---------------------------------------------------------------------- //子函数声明 //---------------------------------------------------------------------- void SYSCLK_Init(void); //系统时钟初始化 void PORT_Init(void); //端口初始化 void UART0_Init(void); //串口UART0初始化 void Send_Char(uchar ch); //发送单个字符 void Send_String(uchar * str, uint len); //发送一个字符串 void UART0_ISR(); //串口中断服务程序,接收字符 void Timer3_Init(uint counts); //定时器3初始化 void Timer3_ISR(void); //定时器3中断服务程序 void ADC0_Init (void); //---------------------------------------------------------------------- //主函数 //---------------------------------------------------------------------- void main(void) {unsigned short i; floAT temp,k; WDTCN = 0xde; //禁止看门狗