汽车半轴加工工艺与编程研发设计.docVIP

毕 业 论 文 论文题目 汽车半轴加工工艺与编程设计 系 别 电子信息工程系 专 业 机械设计制造及其自动化 班 级 学 号 学生姓名 指导教师（签名）_____________________ 完成时间 年 月 ?? 摘要 半轴是汽车的轴类中承受扭矩最大的零件，它是差速器和驱动轮之间传递扭矩的实心轴，其内端一般通过花键与半轴齿轮连接，外端与轮毂连接。该零件在机械设备中具有传动性，在进行汽车半轴的加工工艺分析和编程设计时，以机械制造工艺设计为依据，采用收集研究、分析提取研究及实例研究的方法，对半轴的工艺性进行详细的分析，设计出加工的工艺过程。半轴零件的工艺设计，应尽量降低加工时的成本，减少工人的劳动强度。根据半轴加工要求设计专用夹具，主要是用来钻削半轴圆盘上均匀分布的小孔，在设计中注意夹具的经济性和使用性。 汽车半轴的机械加工工艺分析对从事汽车半轴生产的企业单位来说是很重要的，工艺路线的好坏直接影响到加工效率、加工精度及加工质量。合理的加工工艺路线不但可以保证零件的质量而且可以充分的利用企业现有的设备，使工序的传接更加合理，从而使企业的管理更加的规范化，降低生产成本。 关键词：半轴　工艺分析　夹具设计 Automobile rear axle processing craft and programming design Abstract The semi-axle is the parts of automotive axle with the largest bearing torque. It is the solid axis that transmits torque between the differential mechanism and the driving wheel. Its inner end generally connects by integral-key and semi-axis, outside end connects with hub. The parts have transmission in machinery and equipment. When performing the machining process analysis and programming design of automobile semi-axes, it bases on mechanical manufacturing process design. Use the method of collect research, analysis of extraction and case study with analyzing manufacturability of semi-axis in detail to design manufacturing process. The process design of semi-axis parts should try its best to reduce the cost of processing and the intensity of workers. According to the requirements of the processing of half axle design special jig, mainly used for drilling half axle disk evenly distributed in the design of holes, the economy and practicability attention fixture. Automobile semi-axes machining process analysis for enterprises engaged in production of automobile half shaft is very important and technology will have a direct impact on the efficiency and quality of machining precision and processing. Reasonable processing route will not only ensure the quality of parts and enterprises can make full use of ex