Part 6 - Moving Loads SACST 培训教材.pdf

Part 6 - Moving Loads Preparation 1) Under “Training Project”, create “MovingLoad” subdirectory 2) Copy SACINP.DAT model file, SEAINP.DAT seastate file and PSIINP.DAT soil data from “MasterSlave” directory to “MovingLoad” directory. Modifying seastate SEAINP.DAT to include moving loads Add load case containing only joint load(s) as load(s) to be moved. Add load case FBLV, add joint load F001, Z direction force = -2.0 kN. Add moving load case FBMV, choose FBLV as moving load case; select member group VT1 as loading member group; three moving load step sequences will be added. Moving step sequence 1: from joint F001 to F004 in one (1) step, step size = 1.0 m; Moving step sequence 2: from joint F004 to F005 in ten (10) steps, step size = 2.1471 m; Moving step sequence 3: from joint F005 to F006 in two (2) steps, step size = 0.75 m. The added moving load conditions shall looks like following: LOADCNFBLV LOAD F001 -2.0000 GLOB JOIN MOVLOAD LOADCNFBMV MOVLOD FBLIVE FBLV MOVGRP FBLIVE VT1 MOVSTP FBLIVE 1 1.000 F001 F004 MOVSTP FBLIVE 10 2.147 F004 F005 MOVSTP FBLIVE 2 0.750 F005 F006 Running Seastate program to check moving load generation Create Seastate loading run file and check results from listing file and generated OCI file. Using moving loads in load combination(s) Add moving load case FBMV to load combination OPR3, load factor = 1.0. The modified load combinations shall looks like following: LCOMB LCOMB OPR1 AREA 1.000EQPT 1.000LIVE 1.000MISC 1.000P000 1.100VENT 1.000 LCOMB OPR2 AREA 1.000EQPT 1.000LIVE 1.000MISC 1.000P045 1.100VENT 1.000 LCOMB OPR3 ARE