小学生常规管理制度制度63.doc

六年级（3）班星级班级创建实施方案 好习惯成就一生，坏习惯毁人前程。 temperature piping and equipment, avoid oil pipeline, avoiding vibration equipment, principles of construction of beautiful and neat easy to install. 5.1.5.2 from field instrumentation and valves field junction boxes to the single line slot cable using pipe, 220VAC power cord shall be full pipe laying, indoor coaxial cables concealed and outdoor wear buried. 5.1.5.3 bending cold bending method should be used to protect pipe, bending angle should not be less than 900, when wearing non-armoured cable and laid, bend radius should not be less than 6 times the pipe diameter, when while wearing armored cable and concealed, bend radius should not be less than 10 times the pipe diameter. Bend protection tube there should be no dents, cracks, single right-angled bend protection tube should not be more than two. 5.1.5.4 between protective tube and between protective tube and connector, threaded connections should be used, it tube end screw thread length should not be less than 1/2 of the fitting, and ensures the electrical connection. 5.1.5.5 protection tube should line up, ... 5.1.7 5.1.7.1 check tubing for pressure piping laying pipe, components, materials and specifications meet the design requirements, and have quality certificates, before laying should be cleared by welding and bending the welding slag, rust, chip or a foreign body, and preservative treatments. 5.1.7.2 in pressure piping welding welder must have a valid welder certificate. 5.1.7.3 tubing under the conditions to meet measurement requirements should be as short as possible, General length should not be more than 15m, pipe bending cold bending, cutting machine, minimizing bending and cross, and there shall be no sharp and complex bending, bending radius of not less than 3 times the pipe diameter. 5.1.7.4 pipe and process equipment, piping, or building surface distance is greater than 50mm, not be laid parallel to the oil, combustible, explosive temperature piping a