si3[基础科学]ds2784_ap 单节电池电量计和保护.pdfVIP

AN4043 Storing Fuel Gauge Parameters in the DS2784 Abstract: The DS2784 allows the user to customize the stand-alone fuel gauge to the exact requirements of the application and the cell being used. The parameters required are typically known in units such as mA, V, mAhrs, and mΩ. The DS2784 requires the parameters to be stored in units such as µV, µVhrs and mhos. This application note describes the calculations involved in converting the typical units into units that are actually stored in the device. Introduction The DS2784 stand-alone fuel gauge is simple to use and very accurate, assuming that the correct parameters for the application have been stored in this device. It is very important to store the correct data in order to optimize the fuel gauge. The DS2784K provides an easy way to program the DS2784. The user can input cell characterization and other application data in units such as mA, V, mAhrs, and mΩ, as shown in Figure 1. The DS2784K then converts that data into the format that actually gets stored to the device, as shown in Figure 2. Application Note 3463: Getting Started with the DS2780 describes how to select all of the parameters that are stored in the DS2784. This application note describes the calculations involved in storing these parameters to the device. Figure 1. The Application Units subtab of the Parameters Tab allows the use to enter application data in conventional units, such as mA, V, mAhrs, and mΩ. Figure 2. The Device Units subtab of the Parameters Tab shows the parameters that are actually stored in the DS2784. Calculations Figure 1 shows the parameters that are needed by the DS2784 to operate accurately as a fuel gauge. When the Write Copy button is clicked, the DS2784K software converts the parameters into the format that is act