01----建造方案演示.pptVIP

Block fabrication Our workshop may produce blocks weighing about 200 tons. In the course of block fabrication, we may provide pre-installation of foundation, equipment, piping, cable bearer and iron outfitting according to block pre-installation list for hull, marine machinery, piping, electricity and outfitting present shown in production design. DLS-4200 Proposed Method of Performing the Work Section production plan Stern area Construct in the front with bottom plate as the reference plane and the assembly jig as supporting plates to have reversible deformation. Lay bottom plates and install bilge board with rounded corner. Install longitudinal frame and ribbed panel. Preassemble components like longitudinal bulkhead, transverse bulkhead and exterior panel etc. in platform and lift them up to the assembly jig in sequence. Cover with platform plates, stern transom plates and exterior panels. Measure block shape and levelness then hand over for acceptance. DLS-4200 Proposed Method of Performing the Work Section production plan Interior bottom block Construct in reverse with bottom plate as the reference plane and the assembly jig as supporting plates to have reversible deformation. Preassemble components like ribbed panels, longitudinal girder and pipe casings etc. on platform and lift them up to the assembly jig in sequence for combination. Cover with bottom plates. Check external dimension (length, width, height) of blocks and for any parts missed, then hand over for welding. Apply welding to blocks turned over and supported to horizontality. Measure block shape and levelness then hand over for acceptance. DLS-4200 Proposed Method of Performing the Work Section production plan Middle block 1.Respectively use deck, platform plates, longitudinal bulkhead and transverse bulkhead as the reference plane to construct in reverse the laminar form and used assembly jig as supporting Board. 2.Pre-install components like longitudina