[计算机]2思科设备互联.pptVIP

CISCO网络工程师 内部讲义 Cisco 路由器介绍 配置途径 用主控CONSOLE口接终端配置。 可以在AUX口接一MODEM同电话网相连，在远端配置 在TCP/IP网上可通过仿真终端TELNET配置 可以从TFTP SERVER上下载配置 可用网管工作站进行监控和配置 IOS 的用户界面: 是 CLI (Command Line interface) ，象MS-DOS， unix里面的command line都是 CLI的。而Windows是GUI (Graphic User Interface). CLI的特点是比较难学，但configure 起来比较快。 Cisco 路由器配置途径 Cisco 路由器配置模式 路由器模式一览 用户模式 特权模式 全局配置模式 查看配置情况 show running 和 show startup 命令 配置路由器的各种标识 配置路由器的各种标识 端口配置 配置串口 进入全局配置模式 配置串口 进入全局配置模式 禁用或启用一个接口 确认参数修改情况 给接口配置IP地址 Because IP address is interface specific, you need to go to interface Routerenable Router#config t Router(config)#int s0/0 Router(config-if)#ip address Router(config-if)#int f0/0 Router(config-if)#ip address Router(config-if)#^Z Slide 1 of 2 Purpose: This page shows examples of the commands used to configure a serial interface. Emphasize: Layer 1— In this example, we are configuring the serial interface from the console port. The configure terminal command puts us in global configuration mode. Once in global configuration mode, you must identify the specific interface against which you will be issuing commands. Notice after you enter the specific interface command that the prompt now indicates you are in interface configuration mode. Slide 2 of 2 Purpose: This slide shows two configuration parameters for the serial interface. Emphasize: Layer 2— Issue the clock rate command with the desired speed. On serial links, one side of the link acts as data communications equipment (DCE) and the other side of the link acts as the data terminal equipment (DTE). By default, Cisco routers are DTE devices, but can be configured as DCE devices. In a “back-to-back” cable configuration where a modem is not used, one end must provide the clocking signal. You must specify clock rate for the DCE interface end in this type of environment. Desired clock rate is in bits per second. Be sure to type the complete clock speed. For example, a clock rate of 56000 cannot be abbreviated to 56. If you are using an RS232