01 GMP V4-BC 40x0 HOD HW – QDGM52.ppt

GMP V4-BC 40x0 HOD HW – QDGM52 Contents General Description GMP v4 Cabinet GMP v4 Magazine GMP v4 Board M-MGW Function bearer conversion, supports ATM/ TDM/ IP media stream handling signaling bearer conversions, Signaling Transfer Point (STP) M-MGW is controlled by MSC Connection to External Network Logical and physical interface of the M-MGW Connectivity IP Connectivity: 10 Gbit/s (new in GMP V4), optical 1 Gbit/s, optical/electrical 10/100 Mbit/s FE TDM Connectivity: 155 Mbit/s STM-1/OC-3, optical 1.5/2 Mbit/S E1/T1, electrical ATM Connectivity: 155 Mbit/s STM-1/OC-3, optical 1.5/2 Mbit/s E1/T1, electrical External cables in QDGM52 HW and SW developed history Definition of BC4001 and BC40x0 For single subrack MGw: X is set to 0 as no MSE subrack, and Z is set to 1. This gives 4001. For larger MGw nodes: X is the amount of MSE subracks and Z is for future use (set to 0). This gives 4010, 4020, 4030 and 4040. This whole group is called 40X0. (The Main and Ctrl subracks are mandatory. The different Base Configurations define the amount of MSE subracks. As one MSE subrack is mandatory, the smallest BC is 4010. An important change from GMP V3.0 is that the BCs don’t contain any ETs at all.) Contents General Description GMP v4 Cabinet GMP v4 Magazine GMP v4 Board Cabinet for BC 40x0 HOD Cabinet for BC 40x0 HOD In illustration (BC 40x0 HOD), define different kinds of Magazine in the fixed position, so can distinguish different Function Magazine from its position, also can realize it by included boards. Main/Control/MSE Subrack, they are mandatory magazine. CCF/ECF/APP/OE Converter. PDU: GMP V4 requires high ohmic power distribution (HOD), PDU is the adapter if the power plant only support LOD supply. So PDU only could be fixed in LOD facility. Contents General Description GMP v4 Cabinet GMP v4 Magazine GMP v4 Board Magazine Introduction BFD 528 01/3 is used for all subrack in GMP V4. it contains one Address Strap, one Cable Shelf, one Air guide. BFD 528 01/3 contain