k1需求.docxVIP

Section I. Layer 2 Technologies(18 points)Address allocation (地址分配)Use class B address range yy.yy.x.0/16, YY is your rack number YY is your rack number, X is your router number. （使用B类地址范围，yy.yy.x.0/16,YY是你的机架号，X是你路由器号）EX: If your rack number is 03, Lo0 is and rack number is 07, Lo0 is -Loopback IP AddressUnless specified above, all interface else must be 24 bit mask addressing （除非指定，所有接口必须使用24位掩码地址）?1.设置VLAN\VTP\回环口地址\IP地址------------------------针对session1的，这些属于预配做预配时，先审题，查看1.2的需求和各个设备上的地址是否与自己练习的一样。1.1Troubleshooting Layer 2 Switching Network(4 points)Two faults have been injected into the pre-configuration just described,These issues may impede a working solution for certain portions of this labs exam ，and theseissues,can affect any labs exam section. You must verify that all of YourConfigurations work as expected, if something is not working as expected thenYou must fix the underlying problem.Point will be awarded for solving each problem. However , if you fail to solve a particular problem, and the injected fault prevents you from having a working solutions in any section of this lab , then you will lose points for the fault and the scenario that Is not workingNote: there are no physical faults.All hardware is in working order, and you do not need to physically touch any device or cable to solve a problem.翻译：两处错误已经注入到预配置当中，有问题可能阻碍1.1 Trouble shooting?Sw2:Vtp do ccieroutingandswitchingYYVtp password cisco?On SW2 fastethernet0/10 config “switchport backup f0/4”, this command will cause interfacefasterthernet 0/4 down.1.2 Implement the Access-Switch Ports(4 points)VLAN port assignments are per the following table;（VLAN端口分配按照下面的表格）Configure all of the appropriate nontrunking access switch ports on Sw1,Sw2 and Sw3,according to the following requirements.（配置所有适当的非中继接入交换端口在SW1\SW2和SW3上，通过下面的需求）Configure the VLANs for the switch ports, per the VLAN tables（为交换端口配置VLAN，按照VLAN表格）Include the ports to BB1,BB2 and BB3 （包括到BB1\BB2\BB3的端口）Configure trunk between Sw2-F0/2