电动汽车充电设施互操作性测试方法研究.docVIP

电动汽车充电设施互操作性测试方法研 究 朱彬侯兴哲孙洪亮刘永相汪会财龙羿 国网重庆市电力公司电力科学研宄院 供电设备与电动汽车之间的互操作性测试对电动汽车的推广应用起着特别重要 的作用。文中首先介绍了控制导引电路原理，基于新国标和最新的传导充电互操 作性测试规范设计了交流充电桩和缆上控制与保护装置（1C-CPD）互操作性测 试装置，阐述了互操作性各检测项目的测试目的及评判依据，并对各检测项目 进行了检测及分析。检测结果表明，0前充电桩的互操作性测试主要存在以下问 题：（1）检测点1的电压值超出了 ±0.8 V的容许范围；（2）充电连接控制时序 不符合标准要求；（3）当充电桩在非正常条件下充电结束或停止时，不能在规 定的时间内断开交流供电回路。 关键词： 电动汽车;充电设施;互操作性;测试规范; 朱彬（1982—），男，重庆人，，从事电动汽车充电设施及其检 测技术研宄。Email:zhubin8888_0@163. com 侯兴哲 等技术研宄与应用＜ (1965—), 男， 四川人， ， 筒级工程师，从事电力计量 孙洪亮 宄。 (1980—), 男， 山东人, ， 从事用电信总采集技术研 刘永相 (1978—), 男， 重庆人， ， 从事电动汽车充电设施技术 研宄 汪会财（1985一），男，，从事用电能效与电动汽车充电技术 龙羿（1987—），男，重庆人，，从事电气设备在线监测及电气 工程新技术。 2017-01-25 基金：国家科技支撑计划项目（2015BAG10B00） Study of interoperability test method on electric vehicle charging equipment Zhu Bin Hou Xingzhe Sun Hongliang Liu Yongxiang Wang Huicai Long Yi Electric Power Research Institute of State Grid Chongqing Electric Power Company; Abstract： The interoperability test between power supply equipment and electric vehicle plays an important role in the popularization and application of electric vehicles. The principle of control pilot circuit is introduced firstly in this paper, and then, based on new national standard and the new charging interoperability test specification, the interoperability testing device of AC charging spot and in-cable control and protection device ( IC-CPD) is designed. The test purpose and evaluation of the interoperability test items are stated, and the test items are tested and analyzed. The test results show that the following problems exist in the interoperability test of the charging spot: firstly, the voltage value of the detection point 1 exceeds the allowable range of ± 0. 8 V; secondly, the charging connection control timing does not meet the standard requirements; thirdly, when the charging spot is under abnormal condition, it can’t disconnect the AC power supply loop circuit within the specified time. Keyword： electric vehicle; charging equipment; interoperability; test specifications; Received： 201