[工程科技]伟迪捷170iAF培训教材PPT.ppt

墨水型号 水基 多聚基 酒精基 酮基 丙酮基 技术规格 技术规格 技术规格 技术规格 技术规格 技术规格 技术规格 喷印开机程序 保养开机 保养关机 编辑模式 插入模式 插入模式. 插入模式. 插入模式 系统设置模式 系统设置模式 喷头设置模式 喷头设置模式 喷头设置模式. 传输顺序 墨点充电 服务模式 服务模式 服务模式 故障解决技巧 找出问题细节 (管路或电气). 确定喷头当前状态 (开机，关机，喷头关否） 是否要求循环打印，到服务模式核实故障（不同的原始故障代表不同的意思） 试着把问题分开看. 解决问题后要校验喷印质量. 开始时不知道是什么原因后来才明白. 测试目的: Brass = Air, SS = Ink 自动清洗 关机时自动清洗喷嘴并回收 4 ml 稀释液 关机和刚开始时运行 (除了从服务模式关机) 首次安装时 产品检测 标准型 金属 反射式 接进式 光钎 反射光 对射光 产品检测. 检测方法 散射式 反射式 跳线 E108, E109 喷印开始时; LED PD1 从 OFF到 ON 这个跳线卡设置是以产品的一个边为 开始. 喷头设置模式 喷头设置模式 Animation: 1. Shop air enters regulator forcing piston against spring. 2. Piston move back until force on piston equals force of spring. 3. The difference between the 60 psi output and the 80 psi input is due to the drop of 20 psi across the input orifice as air flows out of the regulator. Question: What will happen to the pressure in the output line if it is blocked such that there is no flow? Animation: 1. Transfer Pressure enter solenoid input. 2. Transfer Pressure is blocked by solenoid actuator. 3. Vacuum is applied to solenoid vent port. 4. This vacuum is felt on the solenoid output due to the actuator being in the deselected state. Animation: 1. +12 volts is applied to the solenoid which causes the actuator to flex allowing Transfer Pressure to the output port and blocks the vacuum present on the vent port. 客户培训不讲了 Animation: Each printhead component is listed and numbered on the printhead one at a time. Question? What effects the viscosity/quality of the ink in the printer and therefor the ability of the printer to provide the proper charging for good print quality? White Board: Ink Viscosity/Quality 1. Temperature 2. Humidity 3. Evaporation 4. Dirt 5. Age Animation: 1. Red circle on line drawing of printhead showing location of Ink Valve. 2. Each fact displayed one at a time. The Ink Control Valve is located in the printhead to prevent drooling from the Nozzle when the ink pressure is turned off. The ink line in the Umbilical exp