Automated System for Combinatorial Synthesis and High-throughput(PPT-44)文档文档.pptVIP

  • 1
  • 0
  • 约3.15万字
  • 约 44页
  • 2018-02-27 发布于湖北
  • 举报

Automated System for Combinatorial Synthesis and High-throughput(PPT-44)文档文档.ppt

Automated System for Combinatorial Synthesis and High-throughput(PPT-44)文档文档

* The block circuit of the electropolymerization set-up is shown on this slide, you can see tht the protected electrodes are connected to the auxiliary electrode through 180kOhm resistor. Two diodes limts the potential ..... * After electropolymerization the library of sensors is synthesized and can be measured. The flow diagram of the measuremet setup is shown in the lower part of this slide. The whole measurement is conreolled by the Automated array measurement software. The user can define all measurement steps which shopuld be performed. According to this definition the software executes all defined steps and stores all results in to database. * The blosk diagram of the measurement set-up is presented on the current slide. - as you can see the same..., only addit... the 4A switch configuration involved in the multiplexer allows to use four-point measurement technique * Four point technique eliminates contact effects allows measurement of bulk polymer conductance To have ossibility to involve four point technique the special topology of electrode sis required Now I wauld like to return and show haw the four point interdigital electrode was developed. lets consider standard four trip structure. If you are folding these strips you will get the most effective using of the surface area. The application of four point technique gives possibility to measure also by two point technique simultaneously. * The simultaneous 2 - and 4- point cnductance meausrement is outlined on the right. As you can see the constant voltage is applied on the outer electrodes by voltage source contrelled by feedbyck from voltmeter V2 and current I is measured. Thius the conductance measured by two point technique is given by the contributio of I nad V2. Simultaneously the potential drop betwen inner electrodes is measured, thus the conductivity by four point technique is given as an contribution of I and V4. Taking into accont the distribution of resistances acrooss the model the ratio betw

文档评论(0)

1亿VIP精品文档

相关文档