年处理能力3.00Mt_a矿区型炼焦煤厂精选.docx

摘 要本设计为年处理能力3.00Mt/a矿区型炼焦煤厂。选煤厂工作制度为每年生产330天，每天16小时，两班生产，一班检修。本设计先对煤质资料进行审查、分析、校正、计算，分析原煤的可选性。在此基础上，通过几个可能的选煤工艺流程，对其进行产品预测和技术、经济比较，选出最佳方案：原煤预先筛分经检查性手选后，+50mm入动筛跳汰机分选，分选出精煤，矸石。分选后精煤破碎与50nn筛下物进三产品重介旋流器分选出精煤、中煤、矸石三种产品。煤泥水采用煤泥直接浮选作业，浮选精煤经加压过滤机脱水，滤饼作为最终精煤产品，尾煤先经浓缩机浓缩，浓缩机底流用压滤机压滤，滤液和浓缩机的溢流作为循环水使用。方案确定后，进行介质、数质量流程计算。依据计算结果，进行设备选型。设备选型时，在满足工艺要求的前提下，优先采用技术先进、性能可靠、效率高、能耗低、成熟可靠的设备。在工艺布置时，做到生产流程通畅，设备布置紧凑，并便于安装、操作和检修。在总平面布置上，对辅助生产设施进行了规划，兼顾了环保的要求。按生产方案生产，产品指标如下：精煤：产率，54.06%；灰分，7，50%；中煤：产率，14.22%；灰分，23.00% ；矸石：产率，17.93%；灰分，85.10%；煤泥：产率：13.78%；灰分，26.50%；关键词： 选煤厂设计 动筛跳 汰 三产品重介旋流器3.00Mt / a Chaili (mine type) Preparation Plant DesignAbstractThe design for the annual processing capacity of 3.00Mt / a coking coal mine type plant . CPP working system for the production of 330 days a year , 16 hours a day , two- shift production , maintenance intervals .The design of the first review of coal quality information , analysis, calibration , calculation, analysis of raw coal washability . On this basis , several possible coal preparation process through its product and technology forecasting , economic comparisons , choose the best solution: after coal pre-screening of hand-selected by check , +50 mm sieve jigging into action machine sorting , sub- elect coal, gangue . After sorting coal crushing and 50nn sieve material into three product heavy medium cyclone elected coal, coal , gangue three products . Slime slime water using direct flotation , flotation concentrate dewatering by pressure filter cake as the final coal products, first by the end of coal concentrate thickener , thickener underflow filter press filter press , and the filtrate concentrated overflow machine as recycled water use .After the plan was finalized, carried out the media , the number of mass flow calculations. Based on the results, for device selection. Equipment selection , to meet the technological requirements of the premise, give priority to advanced technology, reliable performance, high efficiency, low energy