[工学]Section VIII Div 1 and 2 2011 Addenda.ppt

Section VIII Division 1  2011 Code Addenda ChangesUrey Miller - Chair BPV VIII Section VIII Div. 1 2011 Addenda Changes This presentation: Does not discuss all Code revisions Only provides brief summary Covers items of general interest Feel free to ask questions Section VIII Div. 1 2011 Addenda Changes General The 2011 Addenda will be a reprint of the entire book – not just revised sheets After the 2011 Addenda, no future addenda will be published New edition will be published on a two year cycle Next edition will be 2013 Single Mark Code Symbol, ASME Code Symbol becomes Certification Mark“ Code stamped becomes stamped with the Certification Mark“ Code stamp holder becomes Certificate holderCertificate of Authorization Holder becomes Certificate holder“ U, UM, UV and UD Stamps becomes Certification Mark with applicable (U, UM, UD, UV) Designator“ appropriate Code Symbol becomes Certification Mark with appropriate Designator Section VIII Div. 1 2011 Addenda Changes Single Mark - continued Section VIII Div. 1 2011 Addenda Changes Section VIII Div. 1 2011 Addenda Changes Table U-3 Referenced documents in U-3 have been updated Dimensional standards are shown as “Latest Edition” Documents with P/T ratings and specific technical requirements show year of accepted edition BPV Committee wishes to maintain control of technical requirements Several new references have been added Section VIII Div. 1 2011 Addenda Changes TABLE U-3 YEAR OF ACCEPTABLE EDITION OF REFERENCED STANDARDS IN THIS DIV ISION Title Number Year Seat Tightness of Pressure Relief Valves API Std. 527 1991 (R2007)(1) Unified Inch Screw Threads (UN and UNR Thread Form) Pipe Threads, General Purpose (Inch) ASME B1.1 ANSI/ASME B1.20.1 Latest Edition Latest Edition Cast Iron Pipe Flanges and Flanged Fittings, Classes 25, 125, and 250 ASME B16.1 2005 Pipe Flanges and Flanged Fittings ASME B16.5 2009(2) Factory-Made Wrought Buttwelding Fittings ASME B16.9 Latest Edition Forged Fittings, Socket-Weldi