复用机安装验收标准.docVIP

伦拿创透析器复用机安装要求及验收标准 Installation requirements and Acceptance criteria of Dialyzer Reprocessing System 进入安装程序Enter to Setup 将复用机水平放置在复用台面上。台面规格及消毒液的放置（见附件2）。 The reprocessing machine will be placed level on the reuse table. Table specifications and placement disinfectant (see Annex 2) 打开复用机左右两侧的四个十字螺丝，取下机箱盖。 Open on both sides of the machine for about four cross screws, remove the chassis cover 取下水路模块上第2和第3个快速接头管路（见附件3）。 Removed the 2 and 3 quick connector pipeline of the water module 从包装箱中取出容器组合（轻拿轻放），将容器组合放入复用机中预留的位置。 Remove the container combinations from the box (light using light release), put the container combinations into the reserve position. 将润滑剂均匀地涂抹在容器上水嘴接头和下水嘴接头。 Spread the lubricants evenly onto the tap the joint and tap under the joint. 右手将容器提起5厘米，左手将上硅胶管插入容器上水嘴接头，将下硅胶管插入容器下水嘴接头，放下容器，用绑带绑紧上下硅胶管。 Bring containers 5 cm with the right hand, insert the silicone tube into the container tap connector with the left hand, insert the silicone tube under the container into the under the tap connector, put down the container, tied down the silicone tube with bandages. 注意：上下管路应该非常平顺地插入，不得扭曲。 NOTE: The line should be inserted very smoothly, without distorting 从机箱底部拧紧容器组合底部的两个对位孔十字螺丝。 Tightening the two cross to the pore spaces screws at the bottom of the container at the bottom of box 连接好水路模块上第2和第3个快速接头管路，仔细检查容器组合，不得接触任何部件；如有接触，请设法重新安装解决。 Connect the 2 and 3 quick connector pipeline of the water module, double-check the container combinations, shall not contact any components; if contact, try to re-install solution. 将容器组合信号线插在控制板Jweight处，并将信号线用绑带依次绑好。 Plugged the signal line of the containers into the control panel Jweight Department, followed by fixed signal lines with bandages 仔细检查复用机内部控制板和驱动板上的接插件是否牢固，水路一侧的接头和电磁阀安装是否牢固。 Double-check whether the connectors on the control panel and driver board inside the machine is solid, whether the joints and the solenoid valve sea side is solid 将70ml容量球与复用机膜内管路相连接，将复用机膜外管路与膜外连接器相互连接。 Connect 70ml capacity ball and line membra