CCNA学习指南第9章复习题中英文翻译版.docVIP

CCNA学习指南第9章复习题 中英文翻译版 Which of the following is true regarding VLANs? 1.关于VLANs，下列中哪个是正确的？ A. You must have at least two VLANs defined in every Cisco switched network. 你必须至少有两个明确的VLANs在每个Cisco交换网络。 B. All VLANs are configured at the fastest switch and, by default, propagate this information to all other switches. 默认情况下，配置在最快交换机上的所有VLANs 会传播这个信息给所有其它的交换机。 C. You should not have more than 10 switches in the same VTP domain. 你不应该有超过10台交换机在同一VTP域中。 D. VTP is used to send VLAN information to switches in a configured VTP domain. VTP用于发送VLAN信息给在配置的VTP域中的交换机们。 2. According to the following diagram, which of the following describes the router port configuration and the switch port configuration as shown in the topology? (Choose three.) 2. 如下图，下列哪一个描述了显示在拓扑图中的路由器端口配置和交换机端口配置？ A.The router WAN port is configured as a trunk port. 路由器的广域网端口配置为trunk端口。 B. The router port connected to the switch is configured using subinterfaces. 连接交换机的路由器端口配置为使用子接口。 C. The router port connected to the switch is configured at 10Mbps. 连接交换机到路由器端口配置为10Mbps D. The switch port connected to the hub is configured as full duplex. 连接到hub的交换机端口配置为全双工模式。 E. The switch port connected to the router is configured as a trunking port. 连接到路由器的交换机端口配置为trunk端口。 F. The switch ports connected to the hosts are configured as access ports. 连接到主机的交换机端口配置为access端口。 3.A switch has been configured for three different VLANs: VLAN2, VLAN3, and VLAN4. A router has been added to provide communication between the VLANs. What type of interface is necessary on the router if only one connection is to be made between the router and the switch? 3.一个交换机配置了VLAN2,VLAN3和VLAN4三个不同VLANs，添加一个路由器已提供VLANs间的通信。如果在交换机和路由器之间仅有1个链接线，在路由器上哪种接口类型是必须的？ A. 10Mbps Ethernet B. 56Kbps Serial C. 100Mbps Ethernet D. 1Gbps Ethernet 4. You want to improve network performance by increasing the bandwidth available to hosts and limit the size of the broadcast domains. Which of the following options will achieve this goal? 4.你想通过增加到可用主机的带宽和限制广播域