ROUTEChapter86.02012章节练习.docVIP

ROUTE Chapter 8 CCNP 6.0 2012 100% 1. Which method can be used to route traffic through a 6to4 automatic tunnel?IPv6 static routeIPv4 static routeOSPFv2OSPFv3RIPv2RIPng 2. What is an advantage of the NAT-PT technique for transitioning between IPv4 and IPv6?All mappings are static.Globally routable IPv4 addressing is not required.DNS is not required.No configuration is required on end nodes. 3. How do IPv6 enabled routers handle packet fragmentation?IPv6 routers do not perform packet fragmentation. OSPFv3 has a mechanism for determining the optimal packet size and dynamically adjusting the packet size.IPv6 routers do not perform packet fragmentation. CDP is used to discover the correct packet size for any given traffic flow. The correct packet size is unique for each traffic flow.IPv6 routers perform packet fragmentation. CDP is used to determine which packets need to be fragmented for any given traffic flow.IPv6 routers perform packet fragmentation. OSPFv3 has a mechanism for fragmenting packets so that they are the optimal size.IPv6 routers do not perform packet fragmentation. A discovery process is used to determine the optimum maximum transmission unit (MTU) to use during a given session.IPv6 routers perform packet fragmentation. IPv6 built-in QoS mechanisms automatically adjust the packet fragmentation for a given session. 4.Refer to the exhibit. What is the purpose of this configuration?to protect the IPv6 traffic from being corrupted by the IPv4 trafficto transport IPv6 traffic through an IPv4 networkto allow the IPv6 traffic to use IPv4 addressesto encrypt the IPv6 traffic within IPv4 5.Refer to the exhibit. An administrator has configured routers R1 and R2 for EIGRP IPv6 as shown. After completing the configurations and verifying that the interfaces are up, the administrator notes that the routers have not formed an EIGRP adjacency. What needs to be done to allow the neighboring routers to establish adjacency?IPv6 multicast routing mus