超音速火焰喷涂碳化钨-钴涂层磨粒磨损行为研究-中国有色金属学报.PDFVIP

第 25 卷第 7 期 中国有色金属学报 2015 年 7 月 Volume 25 Number 7 The Chinese Journal of Nonferrous Metals July 2015 文章编号：1004-0609(2015)-07-1920-09 超音速火焰喷涂碳化钨−钴涂层磨粒磨损行为 王 群，屈帮荣，唐瞾肸，熊浩奇 (湖南大学 材料科学与工程学院，长沙 410082) 摘 要：采用超音速火焰喷涂工艺在 16Mn 钢上制备了 WC-12Co 涂层，并测试了该涂层的力学性能特别是其抗 磨粒磨损性能。结果表明：WC-12Co 涂层的主相为碳化钨，显微硬度为(1341.0 ±134.3)HV ，孔隙率为 0.21% ±0.04% 。该涂层的磨损率随着磨粒硬度、磨粒粒度和加载载荷的增加而增加。当磨粒的硬度低于涂层硬 度时，涂层的磨损机制以磨耗磨损为主，磨损率低；当磨粒的硬度超过涂层的硬度时，涂层的磨损以微切削为 主，磨损率高。另外，WC-12Co 涂层的耐磨性相对于 16Mn 钢也是随着磨粒的硬度变化而变化。 关键词：WC-Co 涂层；超音速火焰；磨粒磨损 中图分类号：U177.2 文献标志码：A Abrasive wear behavior of WC-Co coating deposited by high velocity oxygen flame process WANG Qun, QU Bang-rong, TANG Zhao-xi, XIONG Hao-qi (College of Materials Science and Engineering, Hunan University, Changsha 410082, China) Abstract: WC-12Co coating was deposited on the 16Mn steel by high velocity oxygen flame (HVOF) process. The mechanical performances, especially, the abrasive wear behavior, of WC-12Co coating were investigated. The results show that the hardness and porosity of the coating are (1341.0±134.3) HV and 0.21%±0.04%, respectively. The wear rate of the WC-12Co coating increases with increasing the hardness, the size and the employed loadings of the abrasives. The abrasive wear mechanism of the WC-12Co coating is mainly abrasion wear and the wear rate is low when the hardness of the abrasive is lower than that of the coating. However, the wear mechanism of the WC-12Co coating is mainly micro-cutting and the wear rate is very high when the hardness of the abrasive is higher than that of the coating. In additi