[英语学习]Oval Rotor Meters Tech Spec.doc

Chapter 4: Technical Specification 4.1 Oval rotor meter requirement: 4.1.1 The specification is the minimum requirement and not detailed. The product proposed shall meet the requirement of actual service conditions. 4.1.2 The product proposed shall meet or beyond the request of datasheet, shall be totally new and totally integrated. 4.1.3 Each meter shall be equipped with 2 filters, one imported with the meter and the other one to be bought domestic. 4.1.4 The product proposed shall meet the condition of datasheet. 4.1.5 The product shall have integrated flange, meeting standard SH3406. Jacket shall not be accepted. 4.1.6 The pressure and temperature rating shall conform to standard ANSI B16.4. 4.1.7 The smoothness of flange surface shall conform to standard ANSI B46.1. 4.1.8 The material of the product shall conform to standard ASTM. 4.1.9 The calculation note shall be given. The calculation note shall include but not limited to following parameters: temperature, pressure, flow rate (max, normal, min), size, flange ranging, min and max flow rate the meter capable of measuring as well as pressure loss, accuracy, repeatability and corresponding curve. 4.1.10 The pressure loss shall not be higher than that of datasheet. 4.1.11 The product shall have permanent flow direction. 4.1.12 Explosion proof shall meet the requirement of datasheet. ATEX certificate shall be provided. 4.1.13 Voltage: 24V DC 4.1.14 Protection = IP65 4.1.15 Accuracy shall not be lower than datasheet. Repeatability and responding time shall be provided. 4.1.16 Output: 4~20mA DC(HART), HART bidirectional communication 4.1.17 Name plate engraved: tag, size, pressure rating, material, ATEX, protection etc and be attached to the body permanently. The material shall be stainless steel. 4.1.18 In case of discrepancy, the term shall be interpreted in the way in favor of the buyer. 4.1.19 The standard catalog shall be provided. 4.1.20 The product origin certificate shall be provided. 4.1.21 The p