卡片冲压模设计毕业设计说明书-应用文.docVIP

学号： 常 州 大 学 毕业设计（论文） （2015届） 题 目 卡片冲压模设计 学 生 林支康 学 院 机械工程学院 专业班级 成型112 校内指导教师 祁红志 专业技术职务 教授 校外指导老师 专业技术职务 二○本课题的研究目标是通过对制件工艺分析，设计出一套可以完成制件的模具 Abstract The research object of this thesis is to design a set of stamping die which can finish the parts by analyzing the structure, dimension and process. Its working principle is the use of the press press equipment of the pressure on the mold, so that the mold in the plate to press out the shape required. Mainly by two processes, one is blanking, two is punching and cutting. Ultimately determine the structure of the die for the longitudinal two pieces of side by side cut open bilateral edge and baffle spacing suppress discharge simulation steps of hop with a bearing plate. Adopt two parts side by side, arrange a molding punch punch, at the same time, two parts of the groove and end forming, and the actual has been two punching parts. Then by a simple oblong shape of blanking punch, local blanking punching, that is, the completion of two parts punching forming process. The punching punch punching width is larger than the width of the punching part, and the two time punching will not leave the dislocation traces at the intersection. The calculation of the size of the bump, the blanking force of the procedure, the calculation of the total blanking force, the calculation of the center of the punch and the center of the punch are also calculated. Mainly has carried on the structure design of die and punch, suppress discharge structure design of structure design of feeding device, the side guide plate and a side edge and so on.At last, the blanking punch, punching punching die, punching punch and die were designed. Key words Card Stamping die;Progressive die;Pressure discharging device. 目录 摘要 I Ab