dehumidification behavior of cross-flow heat exchanger type adsorber coated with aluminophosphate zeolite for desiccant humidity control system：（除湿的行为错流换热器类型吸附剂涂上摘要介绍沸石干燥剂湿度控制系统）.pdfVIP

Applied Thermal Engineering 122 (2017) 618–625 Contents lists available at ScienceDirect Applied Thermal Engineering journal homepage: www.elsevier.c om/locate/apthermeng Research Paper Dehumidification behavior of cross-flow heat exchanger type adsorber coated with aluminophosphate zeolite for desiccant humidity control system Mitsuhiro Kubota a,⇑, Noriko Hanaoka a, Hitoki Matsuda a, Akio Kodama b a Department of Chemical System Engineering, Graduate School of Engineering, Nagoya University, Furo-cho, Chikusa-ku, Nagoya-shi, Aichi 464-8603, Japan b Faculty of Mechanical Engineering, Institute of Science and Technology, Kanazawa University, Kakuma-machi, Kanazawa-shi, Ishikawa 920-1192, Japan a r t i c l e i n f o a b s t r a c t Article history: A cross-flow heat exchanger type adsorber was investigated for a desiccant humidity control system. The Received 2 March 2017 aim of the adsorber was to improve dehumidification performance by forcibly cooling an adsorbent with Revised 7 May 2017 flowing air. Aluminophosphate (AlPO) zeolite was coated on the heat exchanger, because it was expected Accepted 10 May 2017 to regenerate sufficiently even with a low-temperature heat source of around 333 K. Fundamental dehu- Available online 11 May 2017 midification behavior with the adsorber was experimentally investigated at various inlet absolute humidities, regeneration temperatures, and air flow velocities. Dehumidified water in an e